Sherwood RVD-6090R operating instructions Operations, VCR1 VCR2 DVD

Operations

ENGLISH	LISTENING TO A PROGRAM SOURCE
	Before operation

Enter the standby mode.	POWER
	ON/OFF

The STANDBY indicator lights up. This means that the receiver is not disconnected from the AC mains and a small amount of current is retained to support the memorized contents and operation readiness.

To switch the power off, push the POWER switch again.

Then the power is cut off and the STANDBY indicator goes off.

In the standby mode, turn the power on.

1

INPUT SELECTOR

or		POWER
VIDEO	or
AUDIO
CD	TUNER	VCR 1
AUX	TAPE MON. VCR 2
6CH DIRECT		DVD/TV
	INPUT
	SELECTOR

Each time the POWER button on the remote control is pressed, the receiver is turned on to enter the operating mode or off to enter the standby mode.

In the standby mode, if the INPUT SELECTOR button is pressed, the receiver is turned on automatically and the desired input is selected.

Switch the speakers on.

2 SPEAKER

ON/ OFF

Then sound can be heard from the speakers connected to the speaker terminals.

When using headphones for private listening, press the SPEAKER switch again to switch the speakers off.

Select the desired input source.

3	INPUT SELECTOR	CD	TUNER VCR 1
	VIDEO	or
	AUDIO	AUX	TAPE MON. VCR 2

DVD/TV

TAPE MONITOR

Each time the “AUDIO” button is pressed, the input source changes as follows;

TUNER CD AUX (frequency display)

Each time the “VIDEO” button is pressed, the input source changes as follows;

VCR1 VCR2 DVD

When the TAPE MONITOR button is set to on so that “TAPE M” indicator lights up, other inputs can not be heard from the speakers.

To listen to a input source other than TAPE MONITOR, be sure to set the TAPE MONITOR button to off.

TAPE MONITOR function

You can connect either a tape deck or a graphic equalizer to the receiver’s TAPE MONITOR jacks.

To listen to the component connected to these jacks, set the TAPE MONITOR button to on.

If you connect a 3-head tape deck, you can listen to the sound being recorded during recording, not the source sound.

For further details, refer to the operating instructions of the component connected.

When selecting the 6 CH DIRECT as desired, “6-DIRECT” is

displayed and the 6

separate analog	6 CH
	DIRECT
signals from 6 CH
decoder connected to	or	6CH DIRECT

this unit pass through the tone (bass, treble)

and volume circuits only and directly transfer to the speakers. (In case that the TAPE MONITOR button is set to on, the TAPE MONITOR button is automatically set to off.)

To cancel the 6 CH Direct function, press the 6 CH DIRECT button or select the desired input source. These 6 separate analog signals can be heard only, not recorded.

10