GE JGBP33, EGR2001, EGR2002, JGBP29, JGBP28, JGBP32 Leveling the Range, To remove the oven bottom

Page 44

Installation Instructions

7ADJUST BROIL AND OVEN BURNER AIR ADJUSTMENT SHUTTERS IF NECESSARY

Air adjustment shutters for the top and bottom burners regulate the flow of air to the flames.

Air

adjustment shutter

Loosen

The air adjustment shutter for the top (broil) burner is in the center of the rear wall of the oven.

Loosen

Air adjustment shutter

The shutter for the bottom (oven) burner is near the back wall behind the warming drawer, storage drawer or kick panel. Remove the drawer or panel. See the Care and cleaning of the range section.

To adjust the flow of air to either burner, loosen the Phillips head screw and rotate the shutter toward open or closed position as needed.

The flames for the top (broil) burner should be steady with approximately 1″ blue cones and should not extend out over the edges of the burner baffle.

To determine if the bottom burner flames are burning properly, remove the oven bottom. Flames should have approximately 1″ blue cones and, if range is supplied with natural gas, should burn with no yellow tipping. (With most LP gas, small yellow tips at the end of outer cones are normal.) Flames should not lift off burner ports. If lifting is observed, gradually reduce air shutter opening until flames are stabilized.

7ADJUST BROIL AND OVEN BURNER AIR ADJUSTMENT SHUTTERS IF NECESSARY (CONT.)

Oven bottom

To remove the oven bottom:

A. Remove the screws holding down rear of the oven bottom.

B. Grasp the oven bottom at finger slots on each side.

C. Lift the rear of the oven bottom enough to clear the lip of the range frame, push it back, and then pull it up and out.

8LEVELING THE RANGE

A.Install the oven shelves in the oven and position the range where it will be installed.

 

Raise

 

 

range

Lower

 

 

Lower

 

range

range

 

 

Leg leveler

Raise range

(on some models)

(on some models)

B. Check for levelness by placing a spirit level or a cup, partially filled with water, on one of the oven shelves. If using a spirit level, take two readings—with the level placed diagonally first in one direction and then

the other.

C. Remove the storage drawer or kick panel. See the Care and cleaning of the range section. The front leveling legs can be adjusted from the bottom and the rear legs can be adjusted from the top or the bottom.

D. Use an open-end or adjustable wrench to adjust the leveling legs until the range is level.

E. After the range is level, slide the range away from the wall so that the Anti-Tip device can be installed.

44

Page 43 Page 45
Image 44
Page 43 Page 45
Contents Ge.com Write the model and serial numbers here Model # Serial #What to do if YOU Smell GAS Installation Instructions Ge.comSafety Precautions Surface Burners InstructionsCook Meat and Poultry THOROUGHLY… Electric Warming Drawer on some models Operating InstructionsUsing the gas surface burners How to Select Flame SizeBefore Lighting a Gas Burner Sealed Gas BurnersCase of Power Failure Top-of-Range CookwareUsing the oven controls CareOven Temperature Knob on some models Before you begin… Oven VentHow to Set the Oven for Baking or Roasting Preheating and Pan PlacementTroubleshooting Tips Consumer Support Aluminum FoilUsing the oven How to Set the Oven for BroilingBroiling Guide Hi BroilUsing the clock and timer. on some models To Set the TimerTo Set the Clock To Turn Off the Clock DisplayTo Reset the Timer To Cancel the TimerPower Outage Touch the Kitchen Timer On/Off pad twiceHow to Set an Immediate Start and Automatic Stop How to Set a Delayed Start and Automatic StopSpecial features of your oven control. on some models Hour Shut-OffDesigned for use on the Jewish Sabbath and Holidays Using the Sabbath Feature. on some modelsHow to Set for Regular Baking/Roasting Operating Instructions Adjust the oven thermostat-Do it yourself To Adjust the Thermostat on some modelsTo Adjust the Thermostat on models with an Oven Temp Knob Care and CleaningWhen Using the Warming Drawer On Signal LightTemperature Selection Chart To Crisp Stale ItemsHow to Set the Oven for Cleaning Using the self-cleaning ovenBefore a Clean Cycle After a Clean Cycle on some models How to Delay the Start of Cleaning on some modelsTo Stop a Clean Cycle on some models Care and cleaning of the range Standard Twin Burner Assemblies on some modelsInstructions Burner Caps and Heads Burner capsStainless Steel Surfaces on some models Burner GratesCooktop Surface Oven Bottom To clean the inside of the doorLift-Off Oven Door Removable Warming Drawer on some models Removable Storage Drawer on some models Safety InstructionsRemovable Kick Panel on some models To raise the cooktop Oven Air VentsLower Control Panel Front Manifold Panel and Knobs Oven Light Replacement Oven ShelvesDo not remove any screws to remove the cover To replace coverFor Your Safety Part IncludedTools YOU will Need Materials YOU MAY NeedInstallation Instructions Dimensions and Clearances ANTI-TIP Device LocationConnect the Range to GAS Provide Adequate GAS SupplyInstallation Instructions Rigid Pipe Hookup Options Pressure regulator Manifold pipe Electrical Connections Electrical RequirementsCheck Ignition of Oven Burner Check Ignition of Surface BurnersSeal the Openings Leveling the Range To remove the oven bottomInstalling the ANTI-TIP Device When ALL Hookups are CompletedBefore you call for service… See the Using the clock and timer section See the Care and cleaning of the range sectionSee the Installation of the range section Oven temperatureAfter a clean cycle Oven not clean after Clean cycleSelf clean light on When trying to set aPower outage Display goes blankDisplay flashes Unable to getCare and Cleaning We’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration Accessories Looking For Something More?One Year GE Will ReplaceWhat GE Will Not Cover What Mabe Will Not Cover Care and CleaningMabe Will Replace Schedule Service Parts and AccessoriesConsumer Support GE Appliances Website Real Life Design Studio
Top Page Image Contents