Socket
31⁄2”
Maximum length
Bulb
Tab
Glass cover
Oven Light Bulb (on some models)
NOTE: The glass cover (on some models) should be removed only when cold. Wearing latex gloves may offer a better grip.
Before replacing the bulb, disconnect electrical power to the range at the main fuse or circuit breaker panel. Let the bulb cool completely before removing it. For your safety, do not touch a hot bulb with a damp cloth. If you do, the bulb will break.
To remove:
Turn the glass cover counterclockwise 1/4 turn until the tabs of the glass cover clears the grooves of the socket. Remove the bulb.
To replace:
Put in a new
NOTE:
■A
■Reconnect electrical power to the range.
■For improved lighting inside the oven, clean the glass cover frequently using a wet cloth. This should be done when the oven is completely cool.
Safety Instructions Operating Instructions
Adjacent cabinet | Outside edge of |
or final location of | bracket to be |
range side panel | flush with left |
| or right side of |
| range |
| Wall behind |
| range |
|
|
Make sure leg leveler engages slot.
Bracket
Wall plate
Screw must enter wood or metal.
Attachment to wall.
WARNING: All ranges can tip and injury could result. Install the
Tools needed:
■Phillips head screwdriver
■13⁄8″ open end or adjustable wrench
The bracket attaches to floor or wall to hold either the right or left rear leg leveler. If fastening to the floor, be sure that the screws do not penetrate electrical wiring or plumbing. If this cannot be determined, use shorter screws that will not penetrate through flooring.
The bracket is packed inside the oven. Remove and follow the instructions below.
Decide whether the bracket will be installed on the right or left side of the range location.
If the bracket side of the range is adjacent to a cabinet, place the bracket against back wall and cabinet.
If there is no adjacent cabinet, determine where the location of the range side (painted outside panel) will be. Place the bracket with its outside edge at this location and against the back wall.
Determine whether you will anchor the bracket to the floor or wall. Fasten the bracket securely with the screws provided. The screws are self- drilling in wood, plywood, particle and chip board, and most metal framing.
If attaching to masonry you can buy suitable screws and anchors at hardware stores. Use a masonry drill to drill the required holes.
Using the wrench, back out the four leg levelers at least two turns. See the installation instructions for more leveling information before positioning range.
Slide the range into place. Be sure the rear leg leveler fully engages the slot in the bracket.
If the range cannot be moved back far enough for the rear leg leveler to enter the bracket, move the bracket forward as required and attach to the floor in the new location.
23