GE JBC27, JBS26 owner manual Connector block terminal Bare wire

Page 34

Customer Service Troubleshooting Tips Installation Instructions Operating Instructions Safety Information

Installation of the range.

Read these instructions completely and carefully.

7 4-Wire Conduit Installation

Remove the 3 screws from the connector block. Remove the grounding strap from the connector block middle location and the screw connecting it to the frame of the range. Insert bare wires between the connector block terminals and movable nuts. Tighten screws securely. Attach ground wire to the frame of the range.

WARNING: Connector block is approved for copper wire connection only. If aluminum wire is used, see note below.

NOTE: ALUMINUM WIRING

a Do not connect aluminum wire to connector block.

Use copper building wire rated for the correct amperage and voltage to make 3 (three) 3″ copper jumper wires. Connect wire as per Step 6 or 7 depending on number of wires.

b Splice copper wires to aluminum wiring using special connector terminals designed and UL-approved for joining copper to aluminum and follow the connector manufacturer’s recommended procedure closely.

Wire used, location and enclosure of splices, etc., must conform to good wiring practices and local codes.

	Screw	Bare wire tips
	Connector block	Bare wire tips
	Connector block
	Connector block terminal
Bare wire		Grounding
Bare wire		plate
Movable nut	Flexible cable
	Flexible cable
	Bracket	Conduit
		Conduit

34

Image 34

Contents RangesElectric GE Answer CenterCongratulations You Are Now Part of the GE Family Staple sales slip or cancelled check hereWrite the model and serial numbers here GE & You Service Partnership Important Safety Notice All ranges can tip and injury could resultSafety Precautions Safety Information When Cooking PORK… Oven Surface Cooking Units Customer Service Troubleshooting Tips REMEMBER…Surface Cookware Tips Using the surface unitsHow to Set Wok CookingUsing the clock and timer Clock and Timer FeaturesTo Cancel the Timer To Set the TimerTo Reset the Timer To Set the ClockCustomer Service Troubleshooting Using the ovenOven Temperature Knob Before you begin…How to Set the Oven for Broiling Preheating and Pan PlacementAluminum Foil Broiling guide CommentsAdjust the oven thermostat-Do it yourself To Adjust the ThermostatOven Vent Care and cleaning of the rangeControl Panel and Knobs Painted SurfacesTo clean the outside of the door To clean the inside of the doorLift-Off Oven Door Oven Shelves Oven Light Replacement on some modelsOven Heating Elements To remove the coverTo remove the storage drawer How to Remove the Storage Drawer to Clean Under the RangeBroiler Pan & Grid To replace the storage drawerPorcelain Enamel Cooktop Lift-Up Cooktop on some modelsTo remove a surface unit Surface UnitsDrip Pans To replace a surface unitContinuous-cleaning oven cleans itself while cooking To Clean the Continuous-Cleaning Oven Let the range parts cool before handlingPorcelain Oven Interior on some models Installation of the range Before You BeginPrepare the Opening Flooring Under the Range Prepare for Electrical ConnectionPower Cord Strain Relief Installation Strain relief, they can be removed for better fitWire Power Cord Installation Before After Wire Conduit Installation Connector block terminal Bare wire Leveling the Range Anti-Tip Bracket InstallationFinal Check Before you call for service… Food does not Food does not bakeOr roast properly Broil properly At BroilPower outage Oven temperatureClock and timer Too hot or too coldWe Will Replace, At No Charge To You GE Electric Range WarrantyOne Year In-Home Repair Service 800-GE-CARES TDD 800-TDD-GEAC