GE JBC27 Power Cord Strain Relief Installation, Strain relief, they can be removed for better fit

Page 30

Customer Service Troubleshooting Tips Installation Instructions Operating Instructions Safety Information

Installation of the range.

Read these instructions completely and carefully.

3 Power Cord Strain Relief Installation

a Remove the lower rear range wiring cover to expose the connector block and bracket.

b Remove the knockout ring (13⁄8″) located on bracket directly below the

connector. To remove the knockout, use a pair of pliers to bend the knockout ring away from the bracket and twist until ring is removed.

		Knockout ring in bracket.	Knockout ring removed.
		Assemble the strain relief in the hole. Insert the power cord through the
	c
	c	strain relief and tighten. Allow enough slack to easily attach the cord

		terminals to the connector block. If tabs are present at the end of the winged
		strain relief, they can be removed for better fit.

		NOTE: Do not install the power cord without a strain relief.

	Connector box
				Ground
				strap


Wiring cover						Bracket
(shown removed)


	Strain relief		Power cord			Strain relief bracket
						(Provided with range cord. Not part of range.)
						(Provided with range cord. Not part of range.)

30

Image 30

Contents RangesElectric GE Answer CenterStaple sales slip or cancelled check here Congratulations You Are Now Part of the GE FamilyWrite the model and serial numbers here GE & You Service Partnership Important Safety Notice All ranges can tip and injury could resultSafety Precautions Safety Information When Cooking PORK… Oven Surface Cooking Units Customer Service Troubleshooting Tips REMEMBER…Surface Cookware Tips Using the surface unitsHow to Set Wok CookingUsing the clock and timer Clock and Timer FeaturesTo Cancel the Timer To Set the TimerTo Reset the Timer To Set the ClockCustomer Service Troubleshooting Using the ovenOven Temperature Knob Before you begin…Preheating and Pan Placement How to Set the Oven for BroilingAluminum Foil Broiling guide CommentsAdjust the oven thermostat-Do it yourself To Adjust the ThermostatOven Vent Care and cleaning of the rangeControl Panel and Knobs Painted SurfacesTo clean the inside of the door To clean the outside of the doorLift-Off Oven Door Oven Shelves Oven Light Replacement on some modelsOven Heating Elements To remove the coverTo remove the storage drawer How to Remove the Storage Drawer to Clean Under the RangeBroiler Pan & Grid To replace the storage drawerPorcelain Enamel Cooktop Lift-Up Cooktop on some modelsTo remove a surface unit Surface UnitsDrip Pans To replace a surface unitContinuous-cleaning oven cleans itself while cooking To Clean the Continuous-Cleaning Oven Let the range parts cool before handlingPorcelain Oven Interior on some models Installation of the range Before You BeginPrepare the Opening Flooring Under the Range Prepare for Electrical ConnectionPower Cord Strain Relief Installation Strain relief, they can be removed for better fitWire Power Cord Installation Before After Wire Conduit Installation Connector block terminal Bare wire Anti-Tip Bracket Installation Leveling the RangeFinal Check Before you call for service… Food does not Food does not bakeOr roast properly Broil properly At BroilPower outage Oven temperatureClock and timer Too hot or too coldGE Electric Range Warranty We Will Replace, At No Charge To YouOne Year In-Home Repair Service 800-GE-CARES TDD 800-TDD-GEAC