GE XL44 manual Sealed Burner Assemblies on some models, Care And Cleaning, For proper ignition

Page 22
Sealed Burner Assemblies (on some models)
After cleaning, make sure the slot in the burner head is positioned over the electrode.

CARE AND CLEANING

(continued)

CAUTION: DO NOT OPERATE THE BURNER WITHOUT ALL BURNER PARTS AND DRIP PANS (IF SO EQUIPPED) IN PLACE.

Sealed Burner Assemblies (on some models)

Grate

Burner cap

Drip pan

(on some models)

Burner head

Electrode

Turn all controls OFF before removing the burner parts and drip pans (if so equipped).

The burner grates, caps, burner heads and drip pans (if so equipped) can be lifted off, making them easy to clean.

The electrode of

 

the spark igniter is

Electrode

exposed when the

 

burner head is

 

removed. When one

 

burner is turned to LITE, all the burners spark. Do not attempt to disassemble or clean around any burner while another burner is on. An electric shock may result, which could cause you to knock over hot cookware.

Burner Heads (on sealed burners only)

NOTE: Before removing the burner heads and caps, remember their size and location. Replace them in the same location after cleaning.

For proper ignition,

make sure the small hole in the section that fits over the electrode is kept open. A sewing needle or wire twist-tie works well to unclog it.

The slits in the burner heads of your range must be kept clean at all times for an even, unhampered flame.

You should clean the surface burners routinely, especially after bad spillovers, which could clog these openings.

To remove burned-on food, soak the burner heads in a solution of mild liquid detergent and hot water for 20-30 minutes. For more stubborn stains, use a toothbrush.

Before putting the burner head back, shake out excess water and then dry it thoroughly by setting it in a warm oven for 30 minutes.

Replace the burner heads and caps. Make sure that the heads and

caps are replaced in the correct location. There is one small, 2 medium and one large head and cap.

NOTE: On some models the burner heads and caps are all the same size and can be used in any of the 4 needed locations.

Burner Caps (on sealed burners only)

Lift off when cool. Wash burner caps in hot, soapy water and rinse with clean water. You may scour with a plastic scouring pad to remove burned-on food particles.

Dry them in a warm oven or with a cloth—don’t reassemble them wet. Replace the burner caps.

Make sure that caps are replaced on the correct size burner. There is one small, 2 medium and one large cap.

22

small

medium

small

 

medium

 

 

large

medium

large

 

 

 

 

Front of Range

NOTE: On some models the caps are all the same size and can be used in any of the 4 needed locations.

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Care and Cleaning Safety InstructionsInstallation RangesXL44 GasWHAT TO DO IF YOU SMELL GAS Save time and money. Before you request service…HELP US HELP YOU… Read this manual carefullyRead all instructions before using this appliance IMPORTANT SAFETY INSTRUCTIONSImportant Safety Instructions IMPORTANT SAFETY NOTICESurface Cooking SAVE THESE INSTRUCTIONS Cleaning Your RangeBaking, Broiling and Roasting Features and appearance vary FEATURES OF YOUR RANGEMASK FOR SHELVES Clock and Timer on some models Features of Your RangeOven Light On/Off Switch on some models See pageBefore Lighting a Burner SURFACE COOKINGSurface Burner Controls To Light a Surface BurnerTop-of-Range Cookware How to Select Flame SizeDo not use a wok on any other support ring To Change or Cancel the Timer Setting CLOCK AND TIMERTo Set the Timer Display Clock While Timer Is OperatingUsing Your Oven USING YOUR OVENand Timer Before Using Your OvenOven Vents Oven ShelvesShelf Positions locks so when placedBaking How to Set Your Range for BakingBAKING To avoid possible burns, place the shelves in theBaking Guides Pan PlacementPreheating CookiesBaking Pans PiesCakes Don’t PeekTo Adjust the Thermostat ADJUST THE OVEN THERMOSTATThe Type of Margarine Will Affect Baking Performance DO IT YOURSELFUse of Aluminum Foil ROASTINGRoasting Dual Shelf CookingFrozen Roasts Questions and AnswersROASTING GUIDE Q. Why is my roast crumbling when I try toQ. When broiling, is it necessary to always use a grid in the pan? BROILINGBroiling Q. Why are my meats not turning out as brown as they should?BROILING GUIDE The oven and broiler compartment doors must be closed during broilingGuide Care and CARE AND CLEANINGCleaning Standard Twin Burners on some modelsGrate Burner cap Drip pan on some models Burner head Electrode Sealed Burner Assemblies on some modelsFor proper ignition ElectrodeCooktop Surface Care and CleaningBurner Grates Oven BottomRemovable Broiler Drawer on some models Oven Light Bulb on some modelsControl Panel and Knobs Broiler Pan and GridRemovable Storage Drawer on some models Care and CleaningOven Air Vents Removable Kick Panel on some modelsCautions about using spray-on oven cleaners Lift-Off Oven DoorTO CLEAN THE DOOR Do not immerse door in water Inside of door Outside of doorTo Clean the Continuous-Cleaning Oven Special Care of Continuous-Cleaning Oven Interior on some modelsStainless Steel Surfaces on some models Do not scrape the porous surface with a knife orIn the Commonwealth of Massachusetts INSTALLATION INSTRUCTIONSFOR YOUR SAFETY BEFORE YOU BEGIN36 ″ DIMENSIONS AND CLEARANCES361⁄4″± 1⁄4″ 40 ″GENERAL IMPORTANT SAFETY INSTRUCTIONSLOCATION TOOLS YOU WILL NEED PROTECT YOUR FLOORKITCHEN CABINETS PREPARATIONGas Pipe and Electric Outlet Locations 1 PROVIDE ADEQUATE GAS SUPPLY2 CONNECT THE RANGE TO GAS for Models Equipped with Sealed BurnersAlternate Hookup Flexible Connector Hookup for Models Equipped with Sealed BurnersConnector Rigid Pipe Hookup Options for Models Equipped with Sealed BurnersGrounding 2 CONNECT THE RANGE TO GAS continued3 ELECTRICAL CONNECTIONS on some models CAUTION DO NOT USE A FLAME TO CHECK FOR GAS LEAKSElectric Disconnect 4 SEAL THE OPENINGSLight the Surface Burner Pilots Adjust the Surface Burner Pilots if Necessary5 LIGHT THE PILOTS Light the Oven Pilot7 CHECK IGNITION OF OVEN BURNER 6 CHECK IGNITION OF SURFACE BURNERSQuality of Flames A Yellow flamesTo remove the oven bottom Air adjustment shutter LoosenLoosen Air adjustment shutter Oven bottom1. Remove knurled screws holding down rear of oven bottom To remove the broiler drawer11 INSTALLING THE ANTI-TIP DEVICE 2 1⁄ 8 ″10 LEVELING THE RANGE MAKE SURE ALL CONTROLS ARE LEFT IN THE OFF POSITION WHEN ALL HOOKUPS ARE COMPLETEDCONVERTING TO LP GAS Page PROBLEM QUESTIONS? BEFORE YOU CALL FOR SERVICE…Before You Call for Service POSSIBLE CAUSEBEFORE YOU CALL FOR SERVICE… Do It Yourself sectionUnlimited service calls All parts and labor costs included GE Service Protection PlusWarranty Registration Department P.O. Box Louisville, KY We’ll Cover Any Appliance. Anywhere. AnytimeModel Number online at GEAppliances.comFollow these three steps to protect your new appliance investment Serial NumberConsumer Support Schedule ServiceParts and Accessories GE Appliances WebsiteWHAT IS COVERED WARRANTYunder warranty WHAT IS NOT COVERED
Related manuals
Manual 56 pages 39.44 Kb
Top Page Image Contents