GE XL44 manual Electric Disconnect, Seal The Openings

Page 35
Electric Disconnect

AUsage Situations where Appliance Power Cord will be Disconnected Infrequently.

An adapter may be used only on a 15-amp circuit. Do not use an adapter on a 20-amp circuit. Where local codes permit, a TEMPORARY CONNECTION may be made to a properly grounded two-prong wall receptacle by the use of a UL-listed adapter, available at most hardware stores. The larger slot in the adapter must be aligned with the larger slot in the wall receptacle to provide proper polarity in the connection of the power cord.

TEMPORARY METHOD

(Adapter plugs not permitted in Canada)

Align large prongs/slots

Ensure proper ground and firm connection before use

CAUTION: Attaching the adapter ground terminal to the wall receptacle cover screw does not ground the appliance unless the cover screw is metal, and not insulated, and the wall receptacle is grounded through the house wiring. The customer should have the circuit checked by a qualified electrician to make sure the receptacle is properly grounded.

When disconnecting the power cord from the adapter, always hold the adapter with one hand. If this is not done, the adapter ground terminal is very likely to break with repeated use. Should this happen, DO NOT USE the appliance until a proper ground has again been established.

BUsage Situations where Appliance Power Cord will be Disconnected Frequently.

Do not use an adapter plug in these situations because disconnecting of the power cord places undue strain on the adapter and leads to eventual failure of the adapter ground terminal. The customer should have the two-prong wall receptacle replaced with a three-prong (grounding) receptacle by a qualified electrician before using the appliance.

The installation of appliances designed for mobile home installation must conform with the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD, Part 280) or, when such standard is not applicable, the Standard for Manufactured Home Installations, latest edition (Manufactured Home Sites, Communities and Set-Ups), ANSI A225.1, latest edition, or with local codes. In Canada, mobile home installation must be in accordance with the current CAN/CSA Z240/MH Mobile Home Installation Code.

Electric Disconnect

1.Locate disconnect plug on the range back.

2.Pinch sides of connector and pull out of range back.

4 SEAL THE OPENINGS

Seal any openings in the wall behind the range and in the floor under the range when hookups are completed.

35

Page 34 Page 36
Image 35
Page 34 Page 36
Contents RangesXL44 Gas Safety InstructionsInstallation Care and CleaningRead this manual carefully Save time and money. Before you request service…HELP US HELP YOU… WHAT TO DO IF YOU SMELL GASIMPORTANT SAFETY NOTICE IMPORTANT SAFETY INSTRUCTIONSImportant Safety Instructions Read all instructions before using this applianceSurface Cooking Baking, Broiling and Roasting Cleaning Your RangeSAVE THESE INSTRUCTIONS MASK FOR SHELVES FEATURES OF YOUR RANGEFeatures and appearance vary See page Features of Your RangeOven Light On/Off Switch on some models Clock and Timer on some modelsTo Light a Surface Burner SURFACE COOKINGSurface Burner Controls Before Lighting a BurnerDo not use a wok on any other support ring How to Select Flame SizeTop-of-Range Cookware Display Clock While Timer Is Operating CLOCK AND TIMERTo Set the Timer To Change or Cancel the Timer SettingBefore Using Your Oven USING YOUR OVENand Timer Using Your Ovenlocks so when placed Oven ShelvesShelf Positions Oven VentsTo avoid possible burns, place the shelves in the How to Set Your Range for BakingBAKING BakingCookies Pan PlacementPreheating Baking GuidesDon’t Peek PiesCakes Baking PansDO IT YOURSELF ADJUST THE OVEN THERMOSTATThe Type of Margarine Will Affect Baking Performance To Adjust the ThermostatDual Shelf Cooking ROASTINGRoasting Use of Aluminum FoilQ. Why is my roast crumbling when I try to Questions and AnswersROASTING GUIDE Frozen RoastsQ. Why are my meats not turning out as brown as they should? BROILINGBroiling Q. When broiling, is it necessary to always use a grid in the pan?The oven and broiler compartment doors must be closed during broiling BROILING GUIDEStandard Twin Burners on some models CARE AND CLEANINGCleaning Guide Care andElectrode Sealed Burner Assemblies on some modelsFor proper ignition Grate Burner cap Drip pan on some models Burner head ElectrodeOven Bottom Care and CleaningBurner Grates Cooktop SurfaceBroiler Pan and Grid Oven Light Bulb on some modelsControl Panel and Knobs Removable Broiler Drawer on some modelsRemovable Kick Panel on some models Care and CleaningOven Air Vents Removable Storage Drawer on some modelsOutside of door Lift-Off Oven DoorTO CLEAN THE DOOR Do not immerse door in water Inside of door Cautions about using spray-on oven cleanersDo not scrape the porous surface with a knife or Special Care of Continuous-Cleaning Oven Interior on some modelsStainless Steel Surfaces on some models To Clean the Continuous-Cleaning OvenBEFORE YOU BEGIN INSTALLATION INSTRUCTIONSFOR YOUR SAFETY In the Commonwealth of Massachusetts40 ″ DIMENSIONS AND CLEARANCES361⁄4″± 1⁄4″ 36 ″LOCATION IMPORTANT SAFETY INSTRUCTIONSGENERAL PREPARATION PROTECT YOUR FLOORKITCHEN CABINETS TOOLS YOU WILL NEEDfor Models Equipped with Sealed Burners 1 PROVIDE ADEQUATE GAS SUPPLY2 CONNECT THE RANGE TO GAS Gas Pipe and Electric Outlet LocationsRigid Pipe Hookup Options for Models Equipped with Sealed Burners Flexible Connector Hookup for Models Equipped with Sealed BurnersConnector Alternate HookupCAUTION DO NOT USE A FLAME TO CHECK FOR GAS LEAKS 2 CONNECT THE RANGE TO GAS continued3 ELECTRICAL CONNECTIONS on some models Grounding4 SEAL THE OPENINGS Electric DisconnectLight the Oven Pilot Adjust the Surface Burner Pilots if Necessary5 LIGHT THE PILOTS Light the Surface Burner PilotsA Yellow flames 6 CHECK IGNITION OF SURFACE BURNERSQuality of Flames 7 CHECK IGNITION OF OVEN BURNEROven bottom Air adjustment shutter LoosenLoosen Air adjustment shutter To remove the oven bottomTo remove the broiler drawer 1. Remove knurled screws holding down rear of oven bottom10 LEVELING THE RANGE 2 1⁄ 8 ″11 INSTALLING THE ANTI-TIP DEVICE CONVERTING TO LP GAS WHEN ALL HOOKUPS ARE COMPLETEDMAKE SURE ALL CONTROLS ARE LEFT IN THE OFF POSITION Page POSSIBLE CAUSE QUESTIONS? BEFORE YOU CALL FOR SERVICE…Before You Call for Service PROBLEMDo It Yourself section BEFORE YOU CALL FOR SERVICE…We’ll Cover Any Appliance. Anywhere. Anytime GE Service Protection PlusWarranty Registration Department P.O. Box Louisville, KY Unlimited service calls All parts and labor costs includedSerial Number online at GEAppliances.comFollow these three steps to protect your new appliance investment Model NumberGE Appliances Website Schedule ServiceParts and Accessories Consumer SupportWHAT IS NOT COVERED WARRANTYunder warranty WHAT IS COVERED
Related manuals
Manual 56 pages 39.44 Kb
Top Page Image Contents