GE JGBP31GEP, JGBP38GES, JGBP35GEP, JGBP34GEP manual Leveling the Range

Page 43

LEVELING THE RANGE

1.Remove the storage drawer, broiler drawer or kick panel.

2.Use a 3/16” open-end or socket wrench to back out both rear leveling legs approximately two turns.

3.Use a 1%” open-end or adjustable wrench to back out the front leveling legs ho turns.

4.Install the oven shelves in the oven and position the range where it will be installed.

5.Check for levelness by placing a spirit level or a cup, partially filled with water, on one of the oven racks. If using a spirit level, take two readings—with the level placed diagonally first in one direction and then the other.

6.Adjust the leveling’legs until the range is level.

7.After the range is level, slide the range away from

the wall so that the Anti-Tip device can be installed.

INSTALLING THE ANTI-TIP DEVICE

WARNING:

Range must be secured with an approved Anti-Tip device.

c Unless properly installed, the range could be tipped by you or a child standing, sitting or leaning on an open door.

After installing the Anti-Tip device, verify that it is in place by carefully attempting to tilt the range forward.

This range has been designed to meet all recognized industry tip standards for all normal conditions.

The use of this device does not preclude tipping of the range when not properly installed.

If the Anti-Tip device supplied with the range does not fit this application, use the universal Anti-Tip device WB02X7909.

1.Mark the wall where the WGHT EDGE of the range is to be located. Be sure to allow for the countertop overhang if you intend to install the range next to cabinets.

2.bcate the outside edge of the device 2%” toward the center of the range from the marked edge of the range.

3.Using the device as a template, mark the position of the hole for the screw.

4.For wood construction, drill a pilot hole at an angle of 20 degrees from the horizontal. A nail or awl may be used if a drill is not available.

Mount the hti-Tip device witi the screw provided.

For cement or concrete construction, you will need a 1/4” x 1%” lag bolt and a 1/2” O.D. sleeve anchor, which are not provided. Drill the recommended size hole for the hardware.

Install the sleeve anchor into the drilled hole and then install the lag bolt through the device. The bolts must be properly tightened as recommended for the hardware.

5.Slide the range against the wall, and check for proper installation by grasping the front edges of the rear surface unit openings and carefully attempting to tilt the range forward.

WHEN Ml HOOKUPS ARE ~M~ETE~

ME SURE ml CONTROLS ARE LEFT IN THE OFF POSITION.

ME SURE THE FLOW OF ~MBUSTION AND VENTIUTION MR TO THE RANGE IS UNONTRU~ED.

(continued next page)

43

Image 43
Contents Operating Instructions, Tips Ximt Self-Cleaning Gas Range~LP US mLP YOU ~ YOU ~ED ServiceImportant Safety Notice Flames when lifting cookware. Do not use a towel Mportant Safety ~STRUCTIONSKeep all plastics away from top burners Self-Cleaning OvenJGBP26GEN JGBP31GEP JGBP34GEP JGBP35GEP FEATu~s of Your Mnge20,29 To Light a Surface Burner SU~ACE COO~GSurface Burner Controls Before Lighting a BurnerUse of Stove Top Grills How to Select Flame SizeTop-of-Range Cookware Wok Cooking6666 Features of Your OWN ControlOWN CONTROL, Clock Am Tmer USmG Your Oven Surface Light Adjusting the Oven ThermostatOven Moisture Oven VenkBA~G How to Set Your Range for BakingHow to Time Bake How to Set Immediate Start and Automatic StopQuick Reminder BakeBaking Pans Pan PlacementOven Shelf PreheatingCakes Baking GuidesCookies PiesFor Frozen Roasb ROASTmGDual Shelf Cooking Meat Questions and AnswersROAST~G GU~E Oven Doneness Approximate Roasting TimeUse of Aluminum Foil BRO~~GQuestions & Answers Oven door must be closed during broiling Broiling TipsFront Frame Door Gasket Light Before a Clean CycleHow to Set Oven for Cleaning OPEMT~G T~ SELF-CLEA~G OWNHow to Delay Start of Cleaning After a Clean CycleQuick Reminder-Delay Start for Self-Clean Why do I have ash left in my oven after cleaning? Should there be any odor during the cleaning?My oven shelves do not slide easily. What is the matter? Sealed Burner Assemblies on some models ~Grate~Grate CAm Am CLEAN~GCooktop Sutiace Burner GratesOutside of door Lift-Off Oven DoorBroiler Pan and Rack Oven BottomTo remove Control Panel and KnobsTo replace cover Removable Kick Panel on some models Removable Storage Drawer on some modelsTo remove storage drawer Glass Surfaces CAw Am CLEAN~GOven Air Vents Surface Light and Starter on some models~NOR ADmSTmNTS YOU can ~m Broil and Bottom Burner Air Adjustment ShuttersTo remove the oven bottom ~STALLATION ~STRUCTIONS For Your SafetyLM~RTANT Safety Instructions NST&LAmON’tiSTRUCmONS CONMEl IHE Range 10 GAS PROVIDE Adequate GAS Supply‘~~!~Ada,5Ni7euW~w ~m ~~FœMF Connect the Wnge to GMRigid Pipe Hookup for Models Equipped with Sealed Burners IMPORT~-Please read careti~y ELECTRl~L ConnectionsGrounding Extension Cord CautionsYou will have one of tiese Disconnect plugs Power Cord *be Disconnected tiequen@ELE~RIUL CONNE~lONS Electric DisconnectYellow tips on QuaIi~ of Flames%ft blue flame- Normal for natural gas Page Leveling the Range MSTALLATION ~STRUCTIONS HOW to Convert the Range for USE with 1P GM or Natural GASOrifice Spuds for Convetiingto NaturaI Gas Orifice Spuds for Convetiingto LPGasHOW to CONVE~ the Range for USE Broil Burner on some models Oven BurnerTo convert to natiral gas, loosen the spud about 2 turns Yellow tips on outer cones ~STALLATION mSTRUCTIONSYellow flames Yellow tips on outer Soft blue flames A Number Flash on DisplayClean Cycle QUESTIONS? USE this Problem Solver80~626.2000 80WEXARES80W32-Z737Warranty

JGBP31GEP, JGBP34GEP, JGBP35GEP, JGBP38GES specifications

General Electric (GE) has made significant strides in the market of gas ranges, offering a blend of innovation and practicality in its models like the JGBP38GES, JGBP35GEP, JGBP34GEP, and JGBP31GEP. Each of these gas ranges is designed to cater to a variety of cooking needs, providing chefs and home cooks with the tools required for culinary success.

The GE JGBP38GES is a standout model featuring a spacious oven that utilizes a True European Convection system. This technology ensures even heat distribution, allowing dishes to cook uniformly. With a combined oven capacity of 5.0 cubic feet, it offers ample space for multiple dishes at once. The range also includes five sealed burners, which provide precise cooking control from a low simmer to high heat, catering to every cooking style. Its continuous grates make it easy to slide pots and pans across the surface, enhancing efficiency during meal preparation.

The JGBP35GEP model showcases GE's commitment to using advanced technologies for enhanced cooking performance. This model includes a precision touch control panel, providing users with easy access to features and settings. The oven's self-cleaning capability saves time and effort, while the broil feature lets you create delicious crispy edges on meats and vegetables. Its sleek design and durable construction make it an attractive addition to any kitchen.

Moving on to the JGBP34GEP, this appliance stands out with its air fry feature, allowing users to achieve crispy textures without the need for excess oil. The built-in air fry mode is perfect for healthier frying options and offers versatility in cooking styles. It also has a large oven window, enabling cooks to monitor progress without opening the door, which helps maintain temperature consistency.

Finally, the JGBP31GEP model is ideal for those looking for a compact yet powerful range. Despite its smaller size, it delivers a strong performance with four burners and an oven capacity similar to its larger counterparts. Notable is its easy-to-clean surfaces and reliable ignition system, ensuring that every cooking experience is both efficient and refreshing.

Overall, GE's gas ranges exemplify a perfect amalgamation of performance, style, and user-friendly features, making them exceptional choices for modern kitchens. Whether you choose the JGBP38GES, JGBP35GEP, JGBP34GEP, or JGBP31GEP, each model offers something unique while ensuring high quality and reliability.