GE JGBP38 installation instructions Oven Light Replacement on some models, Control Panel and Knobs

Page 32

CARE AND CLEANING

(continued)

Oven Light Replacement (on some models )

CAUTION: Before replacing your oven light bulb, disconnect the electrical power to the range at the main fuse or circuit breaker panel. Be sure to let the light cover and bulb cool completely.

The oven light bulb is covered with a removable glass cover that is held in place with a bail-shaped wire. Remove the oven door, if desired, to reach cover easily.

To remove:

1. Hold a hand under the

 

cover so it doesn’t fall

 

when released. With

 

fingers of the same

 

hand, firmly push back

 

the wire cover holder.

 

Lift off the cover.

Wire cover holder

DO NOT REMOVE ANY SCREWS TO REMOVE COVER.

2.Do not touch hot bulb with a wet cloth. Replace bulb with a 40-watt household appliance bulb.

To replace cover:

1.Place it into the groove of the light receptacle. Pull the wire forward to the center of the cover until it snaps into place. When in place, the wire holds the cover firmly. Be certain the wire is in the depression in the center of the cover.

2.Connect electrical power to the range.

Control Panel and Knobs

It’s a good idea to wipe the control panel after each use of the oven. Clean with mild soap and water or vinegar and water, rinse with clean water and polish dry with a soft cloth.

Do not use abrasive cleansers, strong liquid cleaners, plastic scouring pads or oven cleaners on the control panel—they will damage the finish. A 50/50 solution of vinegar and hot water works well.

The control knobs may be removed for easier cleaning. To remove a knob, pull it

straight off the stem. If knob is difficult to remove, place

a towel or dishcloth between

the knob and control panel and pull gently. Wash the knobs in soap and water or a vinegar and hot water solution.

Metal parts can be cleaned with soap and water. Do not use steel wool, abrasives, ammonia, acids or commercial oven cleaner. Dry with a soft cloth.

Removable Storage Drawer (on some models)

The storage drawer is a good place to store cookware and bakeware. Do not store plastics and flammable material in the drawer.

The storage drawer may be removed for cleaning under the range. Clean the storage drawer with a damp cloth or sponge. Never use harsh abrasives or scouring pads.

To remove the storage drawer:

1.Pull the drawer straight out until it stops.

2.Tilt the front of the drawer up and free of the range.

To replace the storage drawer:

1.Set the stops on the back of the drawer over the stops in the range.

2.Slide the drawer evenly and straight back, so that the rails in the range are engaged.

32

Image 32
Contents Operating Instructions, Tips Safety InstructionsConsumer Services If YOU Need Service Help US Help YOU…Using Your Range Important Safety InstructionsWhen You Get Your Range Surface Cooking Always heat fat slowly, and watch as it heatsBaking, Broiling and Roasting Self-Cleaning OvenClean only parts listed in this Use and Care Guide Features of Your Range Features and appearance may varyFeature Index See Night Light Switch on some models Oven Vents CooktopModel and Serial Numbers Anti-Tip DeviceHOW does this Cooktop Compare To Your OLD ONE? Type of Cooktop Description How it Works Gas BurnersSurface Cooking Top-of-Range Cookware Features of Your Oven Control Appearance may varyOven CONTROL, Clock and Timer Using Your Oven Oven Vents Oven ShelvesShelf Positions Shelves are designed with stop-locks so whenPreheating How to Set Your Range for BakingBaking Pan Placement Baking GuidesCookies Aluminum FoilHow to Time Bake How to Set Immediate Start and Automatic StopTimed Baking Don’t PeekHow to Set Delay Start and Automatic Stop Quick ReminderAdjust the Oven Thermostat Do IT YourselfDual Shelf Cooking RoastingUse of Aluminum Foil Questions and Answers Why is my roast crumbling when I try to carve it?Roasting Guide Frozen RoastsWhy are my meats not turning out as brown as they should? BroilingOven door must be closed during broiling Close the oven doorBroiling Guide Beef SteaksOperating the SELF-CLEANING Oven Before a Clean CycleAfter a Clean Cycle How to Set the Oven for CleaningTo Stop a Clean Cycle How to Delay Start of Cleaning Quick Reminder-Delay Start for Self-CleanShould there be any odor during the cleaning? Why do I have ash left in my oven after cleaning?Care and Cleaning Sealed Burner Assemblies on some modelsTo get rid of burned-on food, place them in a Standard Twin Burners on some modelsRemove the grates and lift out the drip pans Burner Grates Cooktop SurfaceBrushed Chrome Cooktop on some models Oven BottomLift-Off Oven Door Broiler Pan and GridRemovable Storage Drawer on some models Oven Light Replacement on some modelsControl Panel and Knobs Fluorescent Night Light on some models Oven Air VentsRemovable Kick Panel on some models Installation Instructions For Your SafetyImportant Safety Instructions General Provide Adequate GAS Supply Connect the Range to GASConnect the Range to GAS Rigid Pipe Hookup for Models Equipped with Sealed BurnersElectrical Connections on some models GroundingElectrical Requirements Extension Cord CautionsElectrical Connections Electric DisconnectSeal the Openings Check Ignition of Surface BurnersSurface Burner Ignition Quality of FlamesTo remove the oven bottom Installing the ANTI-TIP Device Leveling the RangeConverting to LP GAS Sealed Burner models only Tools RequiredPrepare Range for Conversion Convert the Pressure RegulatorConverting Surface Burners Orifice Spuds for Converting to LP GasOrifice Spuds for Converting to Natural Gas Convert the Oven Burner OrificesAdjust LOW Flame Setting Convert AIR Adjustment ShutterBroil Burner Check for LeaksConverting to LP GAS Standard Twin Burner models only NATConvert the Oven Burner Orifices Oven Burner Top Burner Orifice Drill Size ColorAdjust Oven Thermostat Adjust the Surface Burner PilotsQUESTIONS? USE this Problem Solver Problem Possible CauseProblem Solver Problem Solver Not UnlockProblem Solver Page We’ll Be There Warranty