CAUTION: DO NOT OPERATE THE BURNER WITHOUT ALL BURNER PARTS AND DRIP PANS (IF SO EQUIPPED) IN PLACE.
Standard Twin Burners (on some models)
Grate
Drip Pan
(on some models)
Surface Burner
On models with standard twin burners, the cooktop lifts up for easy access.
Turn all controls OFF before removing burner parts and drip pans (if so equipped).
The burner grates and drip pans (if so equipped) can be lifted off, making them easy to clean.
The holes in the surface burners of your range must be kept clean at all times for proper ignition and an even, unhampered flame.
You should clean the surface burners routinely, especially
after bad spillovers, which could clog these holes. Wipe off surface
burners. If heavy
spillover occurs, remove the surface burners from the range. Burners lift out for cleaning. Lift up the cooktop and then lift out the surface burners.
To remove
Before putting the surface burner back, shake out excess water and then dry it thoroughly by setting it in a warm oven for 30 minutes. Then place it back in the range, making sure it is properly seated and level.
Check the flame pattern of each burner. If the flames are “jumpy” (not steady), clean the holes again with a sewing needle or
Care and Cleaning
Drip Pans (on some models) |
|
Remove the grates and lift out the drip pans. |
|
Drip pans can be cleaned in dishwasher or by hand. |
|
To get rid of |
|
covered container (or plastic bag) with 1/4 cup |
|
ammonia to loosen the soil. Then scrub with a |
|
(continued next page) |
CAUTION: Do not clean the drip pans in the
29