Step Wire System Special Grounding Instructions

2.Aluminum lViring

A. Connect length of copper building wire to range terminal block.

IL Splice copper wires to aluminum wiring using special connectors designed and UT.L. approved for joining copper to aluminum, and follow the connector manufac~urer’s recommended procedure closely.

NOTE: WTire used, location and enclosure of splices, etc., must conform to good wiring practice and local codes.

STEP 5

4-WIRE SYSTEM

SPECIAL GROUNDING INSTRUCTIONS

WARNING:

I;rame grounded to neutral of appliance through a link. If usecl in a MOBILE HOME or if LOCAL CODE3S do not permit grounding through the neutral:

1)disconnect the link from neutral,

2)use grounding terminal or lead to ground unit in accordance with local codes, and

3)connect nrutra] terminal 01- lead to branch circuit in usual manner.

(If the appliance is to be connected bv means of a cord set, use 4-conductol: cord for this p

CO NNECT”O

BL.OCK

4TH G	\ GRO LJND
	LUG

STEP b

ANTI-TIP BRACKET INSTALLATION

AN ANTI-TIP bracket is supplied with instructions for installation in a ~~ariety of locations. The instructions include a template, a parts list and a list f~f tools necessary’ to complete the installation. Read the IMPORTANT SAFETY INSTIKJCTIONS and the instructions that fit your situation before b[ginning installation,

WARNING

1.Range must be secured by ANTI-TIP bracket supplied.

2.See instructions to install (supplied with bracket).

3.Unless properly installed, range could be tipped by stepping or sitting on door. Injury might result from spilled hot liquids or from range itself.

Typical installation of Anti-Tip bracket

Attachment to Wall

Bracket

STEP 7

LEVELING THE RANGE

The range must be level. Leveling feet are located at each corner of the base of the range. Remove the storage drawer or kick panel (depending on your model) and using channel locks, rotate the leveling feet in and out as required to level the range. (For instructions on how to remove and replace the storage drawer or the kick panel, see the Cleaning [Jnder the Range section in Care and Cleaning.) On some models, there are plastic covers which may be removed for easy adjustment (just squeeze and pull).

One of the rear leveling feet will engage the ANTI-TIP bracket (allow for some side to side adjustment). Allow a minimum clearance of l/8- inch between the range and the leveling foot that is to be installed into the ANTI-TIP bracket.

Check the range for proper installation into the ANTI-TIP bracket (after the range has been properly installed) by removing the kick panel or storage drawer and inspecting the rear leveling leg, Make sure it fits securely into the slot.

STEP 8

FINAL CHECK

Be sure all switches are in the OFF position before leaving the range.