GE 164 D2966P073, 49-8549 warranty Before YOU Begin, Read these instructions completely

Page 33

BEFORE YOU BEGIN

Read these instructions completely

and carefully.

IMPORTXNT: Save these instructions for the local electrical inspector’s use.

IMPORTANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES.

NOTE TO INSTALLER: Leave these instructions with the appliance after installation is completed.

NOTE TO CONSUMER: Keep this Use and Care Guide and Installation Instructions for future use.

NU133: l%is appliance must be properly grounded.

TOOLS YOU WILL NEED

●Large blade screwdriver

s Channel lock pliers or small ratchet wrench with 3/16-inch socket (for leveling range)

●l/4-inch hex head nutdriver

ELECTRICAL REQUIREMENTS

CAUTION, FOR PERSONAL SAFETY:

DO NOT USE AN EXTENSION CORD WITH THIS APPLIANCE.

REMOVE HOUSE FUSE OR OPEN CIRCUIT BREAKER BEFORE BEGINNING INSTALLATION.

This appliance must be supplied with the proper voltage and frequency, md connected to an individual, properly grounded branch circuit, protected by a circuit breaker or time delay fuse, as noted on the rating plate.

Wiring must conform to National Electric Codes.

If the electric service provided does not meet the above specifications, it is recommended that a licensed electrician install an approved outlet.

Because range terminals are not accessible after range is in position, flexible service conduit or cord must be used.

STEP 1

PREPARE THE OPENING

lk inch spacing is recommended from the range to adjacent vertical walls above cooktop surface.

Allow 30 inches minimum clearance between surface units and bottom of unprotected wood or metal top cabinet, and 15 inches minimum between countertop and adjacent cabinet bottom.

EXCEPTION: Installation of a listed microwave oven or cooking appliance over the cooktop shall conform to the installation instructions packed with that appliance.

To eliminate the risk of burns or fire by reaching over heated surface units, cabinet storage space above the surface units should be avoided. If cabinet storage is to be provided, the risk can be reduced by installing a range hood that projects horizontally a min. of 5 inches beyond the bottom of the cabinets. Make sure the wall covering, countertops and cabinets around the range can withstand heat generated by the range, oven or cooktop up to 200° E

NOT LESS THAN

WIDTH OF RANGE

II

//

,/-

30” / . ——-==m ——

MIN 15”““--

MIN. ,

y--

4’ ‘m? LOCATE

,—

OUTLET BOX /wlTHi N EITHER

WALL

i

h“ MIN

INSTALL

OUTLET BOX WALL ON EITHER

SIDE OF Q

o ‘?,,..!!%+

Anti-Tip Bracket-w(Install In either rear corner)

{continued next fiagel

33

Page 32 Page 34
Image 33
Page 32 Page 34
Contents Iiia Before .vou request ‘ service Help US Help YOUIf you received Damaged range Read all instructions before using this appliance Important Safety InstructionsOven Self-Cleaning OvenCooktop and Radiant Surface Units Save These InstructionsJBP78 Features of Your RangeDoor Latch 16, 18 How to Set the Controls HOW does this Cooktop Compare To Your OLD ONE?Surface Unit Controls Surface Cookware Tips Goking Guide for Using Heat SettingsSurface COOKWARJ3 Tips How to Check Pan PerformanceRight WRO%G Observe the Following Points in CanningGlass Ceramic Cooktop Cleaning Radiant Surface CleaningHour MIN Wiit Oven CONTROL, Clock and Tinier Oven Shelves Before Using Your C-MmShelf Positions Oven LightBaking How to Set Your Range for BakingPreheating Shelf’ PositionBaking Pans Pan PlacementBaking Guides CookiesHow to Set Immediate Start and Automatic Stop How to Time BakeTimed Baking Don’t PeekHow to Set Delay Start and Automatic Stop Questions and AnswersQuick Reminder To Adjust the Thermostat Adjust the Oven TherimostatUse of Aluminum Foil Roasting. The latch is used for self-cleaning onlyRoasting Why is my roast crumbling when I trv. to carve it?Roasting Guide Frozen RoastsShould I salt the meat before broiling? Why are my meats not turning out as brown as they should?Oven bottom Broiling GuideBefore a Clean Cycle How to Set the Oven for Cleaning Operating the SELF-CLEANING OvenTo Stop a Clean Cycle After a Clean Cycle@ick Reminder HOW to Set Delay Start of Cleaning on some modelsShould there be any odor during the cleaning? Why do I have ash left in my oven after cleaning?My oven shelves do not slide easily. What is the matter? To remove AL,.4 Oven Light Replacement on some modelsCare and Cleaning Oven Heating Elements Lift-Off hen DoorInside of’ the door Outside of’ the doorBroiler Pan and Grid Read these instructions completely Before YOU BeginCopper Wiring Installation InstructionsAluminum lViring Step Wire System Special Grounding InstructionsNormal. Make sure flat-bottomed pans are used QUESTIONS? USE this Problem SolverDo It Yourself section If YOU Need SI!RWCIL Wdll Be There Warranty
Top Page Image Contents