GE JGBC20 installation instructions Commonwealth of Massachusetts, Before YOU Begin

Page 24

Installation Instructions

Range

If you have questions, call 800.GE.CARES or visit our Website at: www.GEAppliances.com

IN THE COMMONWEALTH OF MASSACHUSETTS

•This product must be installed by a licensed plumber or gas fitter.

•When using ball-type gas shut-off valves, they shall be the T-handle type.

•A flexible gas connector, when used, must not exceed 3 feet.

BEFORE YOU BEGIN

Read these instructions completely and carefully.

Installation of this range must conform with local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA.54, latest edition. In Canada, installation must conform with the current Natural Gas Installation Code, CAN/CGA- B149.1 or the current Propane Installation Code, CAN/CGA-B149.2, and with local codes where applicable. This range has been design-certified by CSA International according to ANSI Z21.1, latest edition and Canadian Gas Association according to CAN/CGA-1.1 latest edition.

As with any appliance using gas and generating heat, there are certain safety precautions you should follow. You will find these precautions in the Important Safety Information section in the front of this manual. Read them carefully.

•IMPORTANT — Save these

instructions for local inspector’s use.

•IMPORTANT — Observe all governing codes and ordinances.

•Note to Installer – Be sure to leave these instructions with the Consumer.

•Note to Consumer – Keep these instructions for future reference.

•Note – This appliance must be properly grounded.

•Servicer – The electrical diagram is in an envelope attached to the back of the range.

•Skill Level – Installation of this appliance requires basic mechanical skills.

•Proper installation is the responsibility of the installer.

•Product failure due to improper installation is not covered under the Warranty.

24

Image 24

Contents Non-Self-Cleaning Gas Write the model and serial numbers here Model # Serial #Consumer Support Troubleshooting ANTI-TIP DeviceImportant Safety Notice Safety Instructions Operating InstructionsOperating Instructions Safety Cook Meat and Poultry THOROUGHLY… Surface Burners Surface Burners Using the gas surface burners Tips Installation Instructions OperatingBefore Lighting a Gas Burner How to Select Flame Size Instructions Troubleshooting TipsTop-of-Range Cookware Using the clock and timer To Set the Kitchen TimerTo Change or Cancel the Kitchen Timer Setting Display Clock While Kitchen Timer Is OperatingUsing the oven Before You Begin…Oven Control Oven VentHow to Set the Oven for Baking or Roasting Preheating and Pan PlacementAluminum Foil Oven MoistureHow to Set the Oven for Broiling Broiling Guide SuggestionsBroiling Guide CommentsAdjust the oven thermostat-Do it yourself Safety InstructionsInstructions Troubleshooting Tips Consumer Support To Adjust the ThermostatCare and cleaning of the range Tips Installation Instructions Operating InstructionsStandard Twin Burner Assemblies on some models Safety Burner GratesBurner caps Troubleshooting Tips Consumer Support Cooktop SurfaceTo Order Consumer Support Troubleshooting Tips To clean the outside of the doorLift-Off Oven Door Oven BottomInstructions Operating Broiler Pan and GridRemovable Broiler Drawer on some models Oven Air VentsOven Shelves To Clean the Continuous-Cleaning Oven Commonwealth of Massachusetts Before YOU BeginFor Your Safety Tools YOU will NeedPart Included Materials YOU MAY NeedInstallation Safety Instructions Dimensions and Clearances Location Model and Serial Number LocationConnect the Range to GAS Provide Adequate GAS SupplyInstallation Instructions Alternate Hookup Gas Flow into RangeFlexible Connector Hookup For models equipped with Standard Twin BurnersElectrical Connections Seal the Openings Light the PilotsElectric Disconnect Light the Surface Burner PilotsAdjust the Surface Burner Pilots if Necessary Light the Oven PilotCheck Ignition of Oven Burner Check Ignition of Surface Burners Standing Pilot ModelsElectric Ignition Models Quality of FlamesInstall the ANTI-TIP Device Level the RangeRange must be secured with an ⁄ 8 ″Install the ANTI-TIP Device When ALL Hookups are CompletedBefore you call for service… See the Using the clock and timer section See the Care and cleaning of the range sectionSee the Installation of the range section Oven temperaturePower outage Crackling orPopping sound Rainbow effectWe’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration Accessories Looking For Something More?GE Will Replace What GE Will Not CoverSafety Instructions Operating Camco Will ReplaceWhat Camco Will Not Cover Schedule Service Parts and AccessoriesConsumer Support GE Appliances Website Real Life Design Studio