Installation Instructions
5LIGHT THE PILOTS (cont.)
BAdjust the Surface Burner Pilots if Necessary
CAUTION — Make sure the surface burner control knobs are in the OFF position before attempting to adjust the pilots.
1.Raise the cooktop.
2.Locate the pilot adjustment screw. It can be accessed through the small hole near the center of the manifold panel.
3.To adjust, use a
with a shaft diameter of less than or equal to 3/16″. Turn pilot adjustment screw until pilot flame is 5/16″ high.
Do not reduce the flame to less than 5/16″ or pilot outage may occur. A pilot flame burning higher than recommended may generate soot (carbon black) on the bottom of your cooktop.
CLight the Oven Pilot
1.Remove the oven door. See
2.Remove the oven shelves.
CLight the Oven Pilot (cont.)
3.Remove the oven bottom. To remove:
•Remove knurled screws holding down rear of oven bottom.
•Grasp oven bottom at finger slots on each side.
•Lift rear of oven bottom enough to clear the lip of range frame, then pull out.
Oven bottom
4.Locate the pilot in the back of the oven bottom. The pilot is attached to the left side of the oven burner.
Shield 
(on some 
models) 
Pilot
5.To light the oven pilot, push in and hold the oven control knob while lighting the pilot with a long match or match holder. Once the oven pilot is lit, continue holding the oven control knob for one minute before releasing.
No adjustments are required for natural gas. If the range is connected to LP gas, contact the person who installed your range or made the conversion. If pilot flame does not stay lit, repeat this step.
35