GE JGBC20 Level the Range, Install the ANTI-TIP Device, Range must be secured with an, ⁄ 8 ″

Page 38

Installation Instructions

6LEVEL THE RANGE

AInstall the oven shelves in the oven and position the range where it will be installed.

7INSTALL THE ANTI-TIP DEVICE

WARNING —

• Range must be secured with an

Leg

Raise	Lower
range	Lower
	range

Lower range

approved Anti-Tip device.

• Unless properly installed, the range could

be tipped by you or a child standing,

sitting or leaning on an open door.

leveler

Raise range

(on some models)

(on some models)

B Check for levelness by placing a spirit

level or a cup, partially filled with water,

on one of the oven shelves. If using a

spirit level, take two readings—with the

level placed diagonally first in one

direction and then the other.

C Remove the broiler drawer or kick panel.

See the Care and cleaning of the range

section. The front leveling legs can be

adjusted from the bottom and the rear

legs can be adjusted from the top or the

bottom.

D Use an open-end or adjustable wrench

to adjust the leveling legs until the range

is level.

• After installing the Anti-Tip device, verify

that it is in place by carefully attempting

to tilt the range forward.

• This range has been designed to meet all

recognized industry tip standards for all

normal conditions.

• The use of this device does not preclude

tipping of the range when not properly

installed.

• If the Anti-Tip device supplied with the

range does not fit this application, use the

universal Anti-Tip device WB2X7909.

AMark the wall where the RIGHT EDGE of the range is to be located. Be sure to allow for the countertop overhang if you intend to install the range next to cabinets.

E After the range is level, slide the range

away from the wall so that the Anti-Tip

device can be installed.

Slotted head screw

Anti-Tip

device

Wallplate

Approx. 20°

21⁄8″	Marked edge
	of range

BLocate the outside edge of the device

21⁄8 ″ toward the center of the range from the marked edge of the range.

CUsing the device as a template, mark the position of the hole for the screw.

38

Image 38

Contents Non-Self-Cleaning Gas Write the model and serial numbers here Model # Serial #Consumer Support Troubleshooting ANTI-TIP DeviceImportant Safety Notice Safety Instructions Operating InstructionsOperating Instructions Safety Cook Meat and Poultry THOROUGHLY… Surface Burners Surface Burners Before Lighting a Gas Burner Using the gas surface burnersTips Installation Instructions Operating Top-of-Range Cookware How to Select Flame SizeInstructions Troubleshooting Tips To Change or Cancel the Kitchen Timer Setting Using the clock and timerTo Set the Kitchen Timer Display Clock While Kitchen Timer Is OperatingOven Control Using the ovenBefore You Begin… Oven VentAluminum Foil How to Set the Oven for Baking or RoastingPreheating and Pan Placement Oven MoistureHow to Set the Oven for Broiling Broiling Guide SuggestionsBroiling Guide CommentsInstructions Troubleshooting Tips Consumer Support Adjust the oven thermostat-Do it yourselfSafety Instructions To Adjust the ThermostatStandard Twin Burner Assemblies on some models Care and cleaning of the rangeTips Installation Instructions Operating Instructions Safety Burner GratesBurner caps To Order Troubleshooting Tips Consumer SupportCooktop Surface Lift-Off Oven Door Consumer Support Troubleshooting TipsTo clean the outside of the door Oven BottomRemovable Broiler Drawer on some models Instructions OperatingBroiler Pan and Grid Oven Air VentsOven Shelves To Clean the Continuous-Cleaning Oven Commonwealth of Massachusetts Before YOU BeginPart Included For Your SafetyTools YOU will Need Materials YOU MAY NeedInstallation Safety Instructions Dimensions and Clearances Location Model and Serial Number LocationConnect the Range to GAS Provide Adequate GAS SupplyInstallation Instructions Alternate Hookup Gas Flow into RangeFlexible Connector Hookup For models equipped with Standard Twin BurnersElectrical Connections Electric Disconnect Seal the OpeningsLight the Pilots Light the Surface Burner PilotsAdjust the Surface Burner Pilots if Necessary Light the Oven PilotCheck Ignition of Oven Burner Electric Ignition Models Check Ignition of Surface BurnersStanding Pilot Models Quality of FlamesRange must be secured with an Install the ANTI-TIP DeviceLevel the Range ⁄ 8 ″Install the ANTI-TIP Device When ALL Hookups are CompletedBefore you call for service… See the Installation of the range section See the Using the clock and timer sectionSee the Care and cleaning of the range section Oven temperaturePopping sound Power outageCrackling or Rainbow effectWe’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration Accessories Looking For Something More?GE Will Replace What GE Will Not CoverWhat Camco Will Not Cover Safety Instructions OperatingCamco Will Replace Consumer Support GE Appliances Website Schedule ServiceParts and Accessories Real Life Design Studio