GE JGB915, JGB905 Installing the ANTI-TIP Device, When ALL Hookups are Completed

Page 49

Installation Instructions

9INSTALLING THE ANTI-TIP DEVICE

WARNING!

Range must be secured with an approved Anti- Tip device.

Unless properly installed, the range could be tipped by you or a child standing, sitting or leaning on an open door.

After installing the Anti-Tip device, verify that it is in place by carefully attempting to tilt the range forward.

This range has been designed to meet all recognized industry tip standards for all normal conditions.

The use of this device does not preclude tipping of the range when not properly installed.

If the Anti-Tip device supplied with the range does not fit this application, use the universal Anti-Tip device WB2X7909.

A.Mark the wall where the RIGHT EDGE of the range is to be located. Be sure to allow for the countertop overhang if you intend to install the range next to cabinets.

 

Anti-Tip

 

device

Slotted head

 

screw

Wallplate

 

Approx. 20°

 

2 18Marked edge of range

B. Locate the outside edge of the device 218″ toward the center of the range from the marked edge of the range.

C. Using the device as a template, mark the position of the hole for the screw.

D. For wood construction, drill a pilot hole at an angle of 20 degrees from the horizontal. A nail or awl may be used if a drill is not available.

Mount the Anti-Tip device with the screw provided.

For cement or concrete construction, you will need a 1/4″ x 112″ lag bolt and a 1/2″ O.D. sleeve anchor, which are not provided. Drill the recommended size hole for the hardware.

9INSTALLING THE ANTI-TIP DEVICE (CONT.)

Wallboard

Back of range

 

Anti-Tip device

Wood screw

Install the sleeve anchor into the drilled hole and then install the lag bolt through the device. The bolts must be properly tightened as recommended for the hardware.

E. Slide the range against the wall, and check for proper installation by grasping the front edge of the cooktop and carefully attempting to tilt the range forward.

WHEN ALL HOOKUPS ARE

COMPLETED

Make sure all controls are left in the off position. Make sure the flow of combustion and ventilation air to the range is unobstructed.

CONVERTING TO LP GAS (or

converting back to natural gas from LP)

This range leaves the factory set for use with natural gas. If you want to convert to LP gas, the conversion must be performed by a qualified LP gas installer.

The conversion instructions and LP orifices can be found attached to the range next to the pressure regulator.

Keep these instructions and the orifices in case you want to convert back to natural gas.

49

Image 49
Contents Write the model and serial numbers here Model # Serial # Installation InstructionsAll ranges can tip and injury could result Consumer Support TroubleshootingSafety Instructions Operating Instructions Important Safety NoticeInstructions Surface Burners Instructions Operating Instructions Safety Consumer Support Troubleshooting Tips InstallationTroubleshooting Tips Consumer Operating Instructions Installation InstructionsSupport Troubleshooting Tips Installation Using the gas surface burnersInstructions ConsumerInstallation Instructions Troubleshooting Tips SafetyConsumer Support Oven Control, Clock and Timer Features on some models Using the oven controlsOven Light Pad on some models Troubleshooting Tips Consumer SupportInstallation Instructions Operating Using the ovenTroubleshooting Tips Consumer SupportPreheating and Pan Placement How to Set the Oven for Baking or RoastingAluminum Foil Oven MoistureBroiling Guide How to Set the Oven for BroilingBroiling Guide HI BroilInstallation Instructions Using the clock and timerConsumer Service Consumer Support Troubleshooting Tips Installation Using the timed baking and roasting featuresHow to Set an Immediate Start and Automatic Stop How to Set a Delayed Start and Automatic StopHow to Set the Oven For Cooking When Using the Probe Using the probe. on some modelsInstallation Instructions Installation Instructions Operating Instructions Safety Using the convection oven. on some modelsConsumer Support Troubleshooting Tips How to Set the Oven for Convection Baking or Roasting Troubleshooting Tips Consumer SupportMulti-Shelf Baking Touch the Convection Roast pad Operating Instructions SafetyMeats Convection Roasting GuideSafety Instructions Using the timed convection baking features. on some modelsConsumer Support Troubleshooting Tips Installation Instructions Operating InstructionsSafety Instructions Special features of your oven controlFahrenheit or Celsius Temperature Selection Hour Shut-OffCook and Hold Control Lockout on some modelsHour, 24-Hour or Clock Blackout Cooking function is finishedInstructions Troubleshooting Tips Consumer Support Using the Sabbath FeatureHow to Set for Regular Baking/Roasting Safety InstructionsHow to Exit the Sabbath Feature Safety Instructions Adjust the oven thermostat-Do it yourselfTo Adjust the Thermostat Type of margarine will affect baking performanceWhen Using the Warming Drawer Using the electric warming drawer. on some modelsWarming drawer cannot be used during a self-clean cycle To Use the Warming DrawerInstructions Operating Instructions Installation Instructions Troubleshooting Tips Consumer SupportTemperature Selection Chart To Crisp Stale ItemsConsumer Support Troubleshooting Tips Installation Using the self-cleaning ovenBefore a Clean Cycle How to Set the Oven for CleaningHow to Delay the Start of Cleaning After a Clean CycleSealed Burner Assemblies Care and cleaning of the rangeBurner Caps and Heads Tips Consumer SupportCleaning Consumer Support TroubleshootingBurner Grates Cooktop SurfaceLift-Off Oven Door Troubleshooting TipsOven Bottom Broiler Pan and GridRemovable Drawer Warming Drawer Pan on some modelsTo remove the drawer To replace the drawer Unlock the touch pads after cleaning Safety Instructions OperatingOven Air Vents Upper Control PanelOven Shelves Oven Light ReplacementTo remove Do not remove any screws to remove the coverTools YOU will Need For Your SafetyMaterials YOU MAY Need Electrical Connections in this section Installation InstructionsMinimum Wall on Either side Dimensions and ClearancesLocation ANTI-TIP DeviceConnect the Range to GAS Provide Adequate GAS SupplySee the above section for models JGB900, JGB902 and JGB905 See the below section for model JGB915Rigid Pipe Hookup Options Flexible Connector HookupElectrical Requirements Electrical ConnectionsSeal the Openings Check Ignition of Surface BurnersCheck Ignition of Oven Burner To remove the oven bottom Leveling the RangeWhen ALL Hookups are Completed Installing the ANTI-TIP DeviceProblem Possible Causes What To Do Before you call for service…Oven temperature Control signals afterClock and timer Entering cooking timeAfter a clean cycle Oven not clean after a See the Using the self-cleaning oven sectionClean cycle Is on when you wantDisplay goes blank Power outageDisplay flashes Unable to getLooking For Something More? AccessoriesWe’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration Troubleshooting Tips Consumer Support Operating Instructions Safety InstructionsGE Will Replace What GE Will Not CoverInstructions Installation Instructions Safety Instructions OperatingCamco Will Replace What Camco Will Not CoverConsumer Support GE Appliances Website Schedule Service

JGB915, JGB905 specifications

The GE JGB905 and JGB915 are both standout models within GE's lineup of gas ranges, designed to provide a seamless cooking experience with a focus on modern technology and traditional cooking excellence. Both models feature a sleek, stainless steel design that not only enhances the kitchen's aesthetic but also ensures durability and ease of cleaning.

One of the main features of the JGB905 and JGB915 is their powerful gas burners. These ranges come equipped with multiple sealed burners, allowing for precise heat control. The variances in BTU output across the burners cater to different cooking needs, from simmering sauces to achieving high-heat sears on meats. The center oval burner, available in both models, is especially useful for accommodating larger pans or griddles.

Incorporated into these ranges is GE's advanced Edge-to-Edge cooktop, which maximizes the cooking surface. This design feature allows for the use of oversized pots and pans without sacrificing space or efficiency. Additionally, the continuous cast-iron grates provide a robust cooking surface, making it easy to slide pots from one burner to another.

When it comes to oven performance, both the JGB905 and JGB915 include an innovative convection oven. This technology circulates hot air throughout the oven cavity, promoting even cooking and browning. The ovens also feature self-cleaning options that save time and effort, allowing users to maintain a clean oven with minimal manual scrubbing.

Another characteristic of these models is the inclusion of smart technology. Equipped with built-in Wi-Fi, both ranges allow users to monitor their cooking from their smartphones. This feature adds convenience, enabling remote access to controls and notifications about the oven status, which is particularly helpful when multitasking in the kitchen.

The interior of the ovens is designed for efficiency and ample space, providing multiple rack positions to accommodate different dishes. Interior oven lighting ensures that users can easily check on their meals without opening the oven door, preserving heat and enhancing cooking precision.

In summary, the GE JGB905 and JGB915 gas ranges stand out with their sleek design, powerful burner capabilities, innovative convection technology, smart features, and user-friendly interfaces. These models cater to both novice cooks and culinary enthusiasts, making them excellent additions to any modern kitchen.