Roland GI-20 owner manual Receiving Saved Data Using Midi Bulk Load Midi, Press Write

Chapter 3 Convenient Functions Featured by the GI-20

5.Press [WRITE].

The data is transmitted to the external device from the MIDI OUT and USB connectors.

The following appears in the display during transmission.

Flash

When the display changes back to “dP,” the transmission is finished.

6.If using a sequencer as the receiving device, stop recording.

7.When you have finished the bulk dump, turn the PARAMETER knob back to “PLAY MODE.”

Receiving Saved Data Using MIDI (BULK LOAD (MIDI))

Carrying out BULK LOAD automatically overwrites the settings data stored in the receiving device. Note that this will result in the loss of the data stored up to that time.

1.Connect the external device’s MIDI OUT to the MIDI IN on the GI-20.

2.Turn the PARAMETER knob to “BULK.”

3.Press [SELECT] to select “LM” (LOAD (MIDI)).

4.Transmit the data from the external device.

The following appears in the display during reception.

When the display changes back to “LM,” reception is finished.

5.When you have finished the bulk load, turn the PARAMETER knob back to “PLAY MODE.”

*If you change to another screen (by pressing [SELECT] or by turning the PARAMETER knob) while the data is being received, any data that's been received won't be loaded into the GI-20.

If necessary, start the Bulk Load procedure over from the beginning.

When the data is received correctly, the dot on the display will light.

30