GB
(b) To set the Timer to switch ON immediately and OFF automatically after a set cook period:
Step 1 Check that the correct time of day is set, if not follow instructions for ‘Setting the Time of Day’. Step 2 Place food onto the correct shelf position in the oven(s) and close the door(s).
Step 3 Turn the oven control(s) to the required temperature and if necessary select the appropriate oven function.
Step 4 Press and hold in the Cook Period, the display will read 0.00 and the ‘cookpot’ symbol will light up.
With the Cook Period button still held in, set the required Cook period using the ‘+’ and
Note: Cook Period is the length of time the food requires to cook.
NOTE: The Cookpot symbol disappears
Step 5 Release all buttons.
The timer display will revert to the time of day, with the ‘Auto’ symbol lit and the ‘cookpot’ symbol remaining lit.
At the end of the Cook Period the ‘Auto’ symbol will flash and an intermittent audible tone will be heard. The audible tone will continue unless cancelled. The ‘Auto’ symbol will continue to flash until the Timer is returned to Manual operation (see below).
Step 6 Press the Manual button, the audile tone will be cancelled and the oven(s) will be returned to manual operation.
Step 7 Turn the oven control(s) to the OFF position.
To cancel an Auto Cooking Programme before the Cook Period has finished:
Step 1 Turn the oven control(s) to the Off position.
Step 2 Press the Manual button to return the oven(s) to Manual operation. The ‘Auto’ symbol will go out.
Other notes on Timer operation:
1When cooking automatically the Cook Period can be checked at any time simply by pressing the Cook Period button.
2When cooking automatically the End Time can be checked at any time by simply pressing the End Time button.
3Having set a Cook Period and End Time an electronic device stores the information. The device within the Timer will switch the oven(s) on and off at the required times.
4When setting an Auto Cooking Programme and a mistake is made, to clear:
(a)Press and release the Manual button.
(b)Start the sequence again.
5If at any time the display shows three flashing zero’s 0.00 and ‘Auto’, it is likely that the electricity supply to the oven has been interrupted. Reset the Timer to the correct time of day.
Food in the oven may therefore not have been cooked, before serving check food is thoroughly heated and completely cooked.
6To set each function always press and hold the required function button and at the same time press the ‘+’ or
12