1. General
The appliance is designed for mounting at a safe level into an open housing which must be secured to the backing wall.
2. Oven Housing Cabinets
●The oven unit housing cabinet dimensions must comply with Fig. 4 (see Installation Diagrams).
●An air gap of 50 mm minimum must be provided at the rear of any top or bottom cupboards or shelves Fig. 1 (see Installation Diagrams).
●Ventilation must be unobstructed, ie. from adjacent cabinetry. This can be done by either raising the base of the cabinets using the adjusting feet (or spacers) or alternatively by providing a slot in the cabinet plinth to the dimensions shown overleaf.
●The air gap at the rear allows the warmed air to pass out of the inner cabinet space, but where it is intended to fit cupboards above the oven unit to ceiling height it is essential that the warmed air is exhausted through the front of the cabinet Fig. 1 (see Installation Diagrams).
●If an oven unit is installed adjacent to a tall cabinet, steam escaping from the oven when the door is opened could condense on, and perhaps stain, the adjacent surface. To prevent permanent staining, the adjacent surface should be made of a material that is heat resistant and easy to clean.
Adjacent tall cabinets should not be deeper than the oven housing cabinet.
!IMPORTANT, it is essential that the lower cupboard is constructed in the manner illustrated (see Installation Diagrams), ie. having side, back and roof panels so joined as to provide no apertures which could permit access to the oven unit when installed.
3. Final installation
GB
●Using a spirit level, check that the housing cabinet is level from side to side and from front to back in its installed position.
●Correct any unevenness by placing wooden packing under the bottom of the cabinet. Make sure that the cabinet rests firmly on the cabinet floor without rocking
●Before the oven is fitted, the cabinet must be firmly secured to the backing wall for stability.
●The oven unit should now be lifted (by 2 adults) into the cabinet and pushed fully home.
●Finally the oven unit must be secured to the cabinet by means of the four pozi wash head screws, two through each side trim.
●Remove all packing material from the grill and oven interior.
List of Loose Items
4 x Pozi Wash Head No. 6 x 15mm screws.
3