cleaning and maintenance
WARNING
Electrical Shock Hazard
Plug into a grounded
Do not remove ground prong.
Do not use an adapter.
Failure to follow these instructions can result in death, fire, or electrical shock.
ground
prong
GENERAL RECOMANDATION
✓Important: Before any operation of cleaning and maintenance disconnect the appliance from the electrical supply.
✓It is advisable to clean when the appliance is cold and especially for cleaning the enamelled parts.
✓Avoid leaving alkaline or acidic substances (lemon juice, vinegar, etc.) on the surfaces.
✓Avoid using cleaning products with a chlorine or acidic base.
The oven must always be cleaned after every use, using suitable products and keeping in mind that its operation for 30 minutes on the highest temperature eliminates most grime reducing it to ashes.
ENAMELLED PARTS
✓All the enamelled parts must be cleaned with a sponge and soapy water only or other
Dry preferably with a chamois leather.
STAINLESS STEEL SURFACES (COATED)
CAUTION
✓The STAINLESS STEEL front surfaces used in this range are protected with a Special Lacquer to reduce
To avoid damaging this lacquer, do not clean the stainless steel with abrasive cleaners or abrasive cloths or scouring pads.
ONLY SOAP/WARM WATER MUST BE USED TO CLEAN THE STAINLESS STEEL SURFACES.
STAINLESS STEEL SURFACES (UNCOATED)
The hob + sides are made from uncoated stainless steel.
Can be cleaned with an appropriate stainless steel cleaner.
WARNING
VERY IMPORTANT
Before any operation of maintenance disconnect the appliance from the electrical mains supply.
Do not use steam jet cleaners because the humidity could infiltrate into the appliance making it dangerous.
INSIDE OF OVEN
This must be cleaned regularly.
With the oven warm, wipe the inside walls with a cloth soaked in very hot soapy water or another suitable product.
BURNERS AND GRIDS
✓These parts can be removed and cleaned with appropriate products.
✓After cleaning, the burners and their flame distributors must be well dried and correctly replaced.
✓It is very important to check that the burner flame distributor and the cap has been correctly positioned - failure to do so can cause serious problems.
✓In appliances with electric ignition keep the electrode clean so that the sparks always strike.
✓Note: To avoid damage to the electric ignition do not use it when the burners are not in place.
14