|
|
Fig. 1.4 | Fig. 1.5 |
0 mm |
|
0" |
|
+ 1" 31/32 | Fig. 1.6 |
+ 50 mm |
FITTING THE ADJUSTABLE FEET
The adjustable feet must be fitted to the base of the cooker before use.
Rest the rear of the cooker on a piece of the polystyrene packaging exposing the base for the fitting of the feet.
ATTENTION: Most important! Pay special attention not to damage the range dur- ing this operation.
Fit the 4 legs by screwing them tight into the support base as shown in picture 1.5.
LEVELLING THE COOKER
The cooker may be levelled by screwing the lower ends of the feet IN or OUT (fig. 1.6).
It is important to observe the directions of figure 1.6.
MOVING THE COOKER
WARNING
When raising cooker to upright position always ensure two people carry out this manoeuvre to prevent damage to the adjustable feet (fig. 1.7a).
WARNING
Be careful: do not lift the cooker by the door handle when raising to the upright position (fig. 1.7b).
WARNING
When moving cooker to its final position DO NOT DRAG (fig. 1.7c).
Lift feet clear of floor (fig. 1.7a).
Fig. 1.7a | Fig. 1.7b | Fig. 1.7c |
10