Verona VEFSGE 365 ND manual Setting the Burner Minimum, Semirapid and triple ring burners

			
SETTING THE BURNER MINIMUM
When switching from one type of gas to another, the minimum flow rate must also be
correct: the flame should not go out		even when passing suddenly from maximum to
minimum flame.
To regulate the flame follow the instructions below:
Semirapid and triple ring burners
–  Light the burner
–  Set the gas valve to	position		F
–  Remove the knob
– With a thin screwdriver turn the screw "F" until adjustment is correct (fig. 2.7).
Inside crown of DUAL burner			Fig. 2.7
–  Light the DUAL burner
–  Set the gas valve to	position
–  Remove the knob			H
– Using a screwdriver turn the screw "H" until the correct setting is obtained (fig. 2.8).
Outside crowns of DUAL burner			G
–  Light the DUAL burner
–  Set the gas valve to	position
–  Remove the knob
– Using a screwdriver turn the screw "G" until the correct setting is obtained (fig. 2.8).

For LP/PROPANE gas, tighten the adjustment screws completely.

Fig. 2.8

21