Wire Power Cord Installation | Verona VEFSGE 365 ND specs

3-Wire Power Cord Installation

(See Figures 3.1, 3.2 and 3.3)

1.	Remove the Terminal Block Access Plate on the back of the
	range by unscrewing the 6 fixing Screws (fig. 3.1).
2.	Insert the Power Cord through the hole in the Power Cord
	Bracket; then tighten the Power Cord by using a suitable
	Strain Relief. Allow enough slack to easily attach the cord
	terminals to the Terminal Block.
3.	Remove the 3 wire terminal nuts and washers from the
	Terminal Block.
4.	Plug the terminal holes of Power Cord. The Neutral or
	Ground Wire of the Power Cord must be connected to the
	neutral terminal located in the center of Terminal Block. The
	Power Wires must be connected to the outside terminals.
5.	Plug washers and tighten nuts securely.



Fig. 3.1

Screws

Terminal Block

Access Plate

Do not remove Ground strap.

6. Assemble the Terminal Block Access Plate.

4-Wire Power Cord Installation

(See Figures 3.1, 3.2 and 3.4)

Fig. 3.2

Power Cord

Bracket

Hole D 1" 9/64 (29 mm)

1.	Remove the Terminal Block Access Plate on the back of the
	range by unscrewing the 6 fixing Screws (fig. 3.1).
2.	Insert the Power Cord through the hole in the Power Cord
	Bracket; then tighten the Power Cord by using a suitable
	Strain Relief. Allow enough slack to easily attach the cord
	terminals to the Terminal Block.
3.	Remove the 3 wire terminal nuts and washers from the
	Terminal Block.
4.	Remove the Ground Strap from the frame of range and
	terminal by removing its screw and cutting it as shown in
	Figure 3.4.
5.	Plug the terminal holes of Power Cord. The Neutral Wire of
	the Power Cord must be connected to the neutral terminal
	located in the center of Terminal Block; the Power Wires
	must be connected to the outside terminals; the Ground Wire
	must be attached to the frame of range by using the

	(Ground) identified Grounding Screw.

6.	Plug washers and tighten nuts securely.

Fig. 3.3

Ground strap

Terminal Block

Tighten the Power Cord

by using a suitable Strain Relief

Neutral Wire

Power Wires

Power Cord

7. Assemble the Terminal Block Access Plate.

Fig. 3.4

Cut Ground Strap

Terminal Block

Grounding

Screw

Grounding Wire

Neutral Wire

Power Wires

Tighten the Power Cord	Power Cord
by using a suitable Strain Relief