Attach tip-over brackets | GE Monogram ZCG3100, ZCG3500, ZCG3300

Step 5 Attach tip-over brackets

Installation

Built-In Compactors

Position tip-over brackets on the top of the compactor. Match hole #3 of the bracket to the screw hole on the compactor (the 3rd hole on the bracket is the standard location). Attach tip-over bracket to compactor with one slotted head screw on each side.

•Remove the compactor drawer for easier handling.

•Then position the compactor just in front of the cabinet opening.

•PLUG POWER CORD INTO THE WALL RECEPTACLE.

•Slide compactor back into cabinet opening.

Note: Make certain that the leveling feet caps are on the leveling feet and the power cable is not under compactor.

The short leg of anti-tip bracket should be completely under the lip of the countertop but not so far back that the screws can’t be put in. If the bracket is not in the proper location, pull the compactor back out far enough to get to the top screws and reposition the bracket to the appropriate hole.

Drill (4) 1/8" dia. x 1/2" deep pilot holes in the underside of the countertop at the location of the four holes in the short leg of the anti-tip bracket.

Caution: Do not drill up through the top of the countertop.

Secure anti-tip bracket to countertop with 4 Phillips

head screws (supplied) on each side.

Compactor Top

Countertop Overlap