Installation
Built-In Compactors
Procedure D
3/4" thick wood panel with custom handle
• Pull the drawer out to stop position.
•Unlatch the drawer front by opening the clasp on the right side.
•While supporting the weight of the drawer front, remove the hinge pins on the left side.
•Lay drawer front face down on a flat surface.
•Remove 9 screws which retain the front panel and handle.
–Save galvanized inner door.
–Discard front panel with side trim and handle.
•Place galvanized inner door onto the back side of the finished panel.
•Position the inner door
•Use the inner door as a template. Drill 2 pilot holes near the top and 2 at the bottom, sized to match screws being used. (Screws are not provided)
•Drive 2 screws loosely into the bottom and 2 screw into the top. Check to be sure the inner door is centered left to right over the finished panel. Tighten screws.
Caution: Select screw length carefully to avoid penetration of the finished side.
C |
L |
Back Side Finished Panel
Galvanized Inner Door
C |
L |
Back Side Finished Panel |
Galvanized Inner Door |
14