Step 7 Changing front panel (ZCG3300 and 3100 only)
Installation
Built-In Compactors
Remove compactor drawer by pulling it out until it stops. Then lift the drawer to clear second stop and remove drawer. Place drawer on its back.
Procedure A
Reverse color panel
Remove the two screws in the bottom edge of the trim. Slide panel out, turn it over and slide back in. Reinstall trim.
Optional custom panels (ZCG3300 and 3100 only)
Procedure B
1/4" thick wood panel
Proceed as in “A” above, but discard the aluminum color panel and cardboard spacer. Slide 1/4" panel into trim. Reinstall trim.
Procedure C
3/4" thick wood panel with supplied handle
•Pull the drawer out to stop position.
•Unlatch the drawer front by opening the clasp on the right side.
•While supporting the weight of the drawer front, remove the hinge pins on the left side.
12