SECTION 4 MAINTENANCE
6. Reconnecting the inside master links (Figure
H. Attaching Drive Chain
1.If drive sprocket assembly was removed, reassemble it onto the conveyor drive shaft. Be sure flat on end of drive shaft aligns with set screw in conveyor shaft collar. Once in place tighten 3/32” set screw.
2.Lift conveyor and install drive chain to conveyor drive sprocket and motor sprocket.
Figure
NOTE: The outside master links have right and left sides to them. The right edge master link has an open hook facing you as shown in Figure
Figure
3. The angle plate located on the underside of the conveyor must be against the lower end plug. This is true on both sides of the oven.
Figure
7.Reconnect the outside master links.
8.Replace all parts removed from the oven.
Crumb Pan
Mounting Bracket
Lower End Plug
Figure
Figure
26