Middleby Cooking Systems Group PS520E specs

SECTION 4

MAINTENANCE

E. Conveyor Reassembly Into Oven

1. Lift conveyor and position it in the oven as shown.

NOTE: Conveyor may be inserted into either end of the oven. If it is ti be installed from the non-drive end of the oven the drive sprocket assembly must be removed as shown in conveyor disassembly section.

Figure 4-21

2. Reinstall the conveyor extension.

F. Checking Conveyor Belt Tension

WARNING

Oven conveyor belt must be cool when adjusting belt. Do not adjust belt if HOT.

1.With the conveyor assembly in the oven, stand at one end of the conveyor and check tension by lifting the conveyor belt at the center of the oven chamber opening (see Figure 4-23). The belt should not lift higher then 1” to 2” (75mm to 102mm).

2.If conveyor belt is still not under proper tension, an entire link must be removed. Use the following procedure “H. Conveyor Belt Link Removal” to remove a link. If conveyor belt is under proper tension proceed directly to “J. Attaching Drive Chain”.

3.Newer model PS520-Series ovens have adjustment screws at the end to tighten the conveyor belt. If these adjustment screws are at their limit and belt tension is still not correct, loosen the adjustment screws, proceed to “H. Conveyor Belt Link Removal” to shorten the belt and then return to “F. Checking Conveyor Belt Tension” for proper adjustment. If belt is tensioned properly proceed directly to “J. Attaching Drive Chain”.

Conveyor Extension

Figure 4-22

Figure 4-23