4
LOCAL CODES PRODUCT FEATURES GLOSSARY OF TERMS
Location and Space Requirements
LOCAL CODES
Install and use stove and burner system with care. Follow all local codes. In the absence to local codes, use the current National Fuel Gas Code ANSI Z223.1/NFPA 54* (USA) or the current CSA- B149.1 Installation Code (Canada).
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
PRODUCT FEATURES
OPERATION
This cast iron stove with burner system is clean burning and vents easily through outside walls or vertically using outside air for combustion. Heat is generated by both realistic flames and glowing embers. When used without the blower accessory, the stove with burner system requires no electricity making it ideal for emergency backup heat.
PIEZO IGNITOR
This burner system has a piezo ignitor. This system requires no matches, batteries, or other sources to light burner system.
GLOSSARY OF TERMS
Chase - A boxlike enclosure to protect venting from the elements when the venting run is on the outside of a structure.
Mastic - A pliable sealant for use around the vent terminal.
Snorkel Termination - A box that raises the horizontal termination above ground level clearances.
Vent Terminal - Mounted on an outside wall or roof to separate the inlet and outlet of the vent system and protect it from weather.
Vinyl Siding Standoff - A metal box that separates the vent cap from vinyl siding.
Wall Thimble/Firestop - A metal plate used to secure the vent pipe when it passes through a wall or ceiling.
PRE-INSTALLATION
PREPARATION
WARNING: A qualified service person must in- stall stove and burner system. Follow all local codes.
CAUTION: This stove with burner system creates warm air currents. These currents move heat to wall surfaces next to stove. Installing stove next to vinyl or cloth wall coverings or operating stove where impurities (such as, but not limited to, tobacco smoke, aromatic candles, cleaning fluids, oil or kerosene lamps, etc.) in the air exist, may discolor walls or cause odors.
LOCATION AND SPACE REQUIREMENTS
Determine the safest and most efficient location for your Comfort Glow cast iron stove. Make sure that rafters and wall studs are not in the way of the venting system. Choose a location where the heat output is not affected by drafts, air conditioning ducts, windows, or doors. Figure 2 shows some common locations. Read all venting information in this manual. Be aware of all restrictions and precau- tions before deciding the exact location for your stove.
When deciding the location of your stove, follow these rules:
1.Do not connect this stove and burner system to a chimney flue serving a separate
2.Due to high temperatures, do not locate this stove in high traf- fic areas or near furniture or draperies.
3.Proper clearances must be maintained, see Figures 3 and 4 on page 5.
4.This stove is a freestanding unit designed to set directly on the floor. If your stove is to be installed directly on carpeting, vi- nyl tile, or any combustible material other than wood, it must be installed on a metal or wood panel extending the full width and depth of the stove. See Figure 5, page 5.
On Wall with
Horizontal
Termination
On Wall with |
|
Vertical Termination |
|
Through Ceiling | Corner Installation |
Figure 2 - Common Stove Locations |
|
For
.
.com
