Desa Tech CDVBPC manual Installing DIRECT-VENT Burner System Into Stove Body, Attaching Stove Door

CAST IRON STOVE AND DIRECT-VENT BURNER SYSTEM ASSEMBLY

Stove Body Assembly (Cont.)

Installing Direct-Vent Burner System Into Stove Body

7

CAST IRON STOVE AND DIRECT-VENT BURNER SYSTEM ASSEMBLY

Continued

10.Install door catch bolt (M8 x 1.25-55mm with two M8 hex nuts) into threaded hole on stove body (see Figure 9, page 6). Use an adjustable wrench or a 12mm socket. The catch bolt has two hex nuts attached to it (see Figure 12). The top nut is a bolt stop and the bottom nut is for door leveling adjustment.

11.Check general catch bolt alignment with door claw. Make fi- nal adjustment and door leveling after stove is in normal stand- ing position.

12.Carefully lift stove back up on its four attached legs.

13.Set top grate into stove top.

INSTALLING DIRECT-VENT BURNER SYSTEM INTO STOVE BODY

1.Carefully lift burner system and place into stove body from the rear of stove.

2.Using screws provided, attach burner system to back of stove.

Screw

Burner

System

Cast Iron

Stove Body

Stove

Door

Door

Hinge

Step Bolt

Threaded Hole

Bolt Shoulder

Figure 11 - Attaching Stove Door

Figure 13 - Installing Burner System Into Cast Iron Stove Body

Door Claw

Door

Bolt Stop

Adjusting Nut

Catch Bolt

Figure 12 - Catch Bolt and Door Claw Orientation

For morevisit www..com

105501-01G