FCI Home Appliances TCCB 36, ECCB 30, TCCB 30 installation manual Wire branch circuit, Serial plate

				Installation Manual
			Models ECCB/TCCB 30” – 36”		ENGLISH
Recommended Minimum
kW Rating on	Circuit protection	Wire size
serial plate	in amperes	(AWG)
0-4.8	20	12
4.9-6.9	30	10
7.0-9.9	40	8
10.0-11.9	50	8
12.0-14.9	60	6
Be sure your appliance is properly installed and
grounded by a qualified technician. Ask your
dealer to recommend a qualified technician or an
authorized repair service. This cooktop does not
require a neutral connection. If the cooktop Is to
be completely enclosed In a cabinet, feed the
cooktop cable through the opening in the cabinet.
Make the electrical connection following the
appropriate steps for your installation.
This appliance is manufactured with a green ground
wire connected to the cooktop chassis. After making			Figure 14.
sure that the power has been turned off, connect the
flexible conduit from the cooktop to the junction box			4-Wire branch circuit
using a U.L. listed conduit connector. Figures 14 and
15 and the instructions provided below present the			Refer to figure 15:
most common way of connecting the cooktops. Your			1. Connect the green ground wire from the cooktop
local codes and ordinances, of course, take				to the ground wire in the junction box (bare or
precedence over these instructions. Complete				green colored wire).
electrical connections according to local codes and			2. Connect the red and black leads from the cooktop
ordinances
				to the corresponding leads in the junction box.
	DANGER		3. Connect the white wire from the cooktop to the
				neutral (gray or white) wire in the junction box.
Risk of Electric Shock, frame grounded to			4.	Terminate and insulate the neutral (gray or white
				colored wire) in the junction box.
neutral of appliance through a link.

Grounding through the neutral conductor is prohibited for new branch-circuit installations (1996 NEC); mobile homes; and recreational vehicles, or in an area where local codes prohibit grounding through the neutral conductor.

3-Wire branch circuit

Where local codes allow the connection of ground wire from the cooktop to the branch circuit neutral wire (gray or white colored wire) proceed as follows (see figure 14).

1. If local codes permit, connect the green GROUND wire from the cooktop to the branch circuit neutral wire (gray or white colored wire).

2. Connect the red and black leads from the cooktop to the corresponding leads in the junction box.

Figure 15.

13