Keurig B155 De-Scaling Instructions, Service, Storage, Drain the water from the Internal Hot

Page 17

De-Scaling Instructions

A. PREPARE

Step 1: Make sure you have at least 90 oz. of undiluted white vinegar

on hand. You will also need an empty sink and a large ceramic mug (do not use a paper cup).

Step 2: Empty the water in the Water Reservoir.

Step 3: Disable “Auto Off” and programmed “On Off” time (pages 13-14).

B. FILL AND CLEAN

Step 1: Pour the vinegar into the Water Reservoir to fill it.

Step 2: Place a large mug on the Drip Tray Plate and run a water brew cycle. DO NOT USE A K-CUP,just select the Large Mug brew size. Pour the contents of the large mug into the sink.

Step 3: Repeat the brew process 3 times.

Step 4: Let the Brewer stand for at least 4 hours while still on.

C. RINSE

Step 1: Ensure the Water Reservoir is filled with fresh water.

Step 2: Place a large mug on the Drip Tray Plate and run a water brew cycle. Pour the contents of the large mug into the sink.

Step 3: Repeat brew process until the Water Reservoir is empty.

Step 4: You may need to perform additional water brew cycles if you notice any residual taste or odor.

Service

Beyond these recommended cleaning and maintenance procedures this Brewer is not user serviceable. For service, please refer to the Warranty section of this guide.

Storage

Draining the Brewer

1.Turn off the brewer, unplug it, and allow the brewer to cool approximately 30 minutes.

2.Empty the Water Reservoir by first removing the Lid from the Water Reservoir then lifting the Water Reservoir straight up and toward the right of the brewer (may be tight). Rinse and Empty the Water Reservoir.

3.Turn the brewer around so the back is facing out. Unscrew the small knob to release the back panel, remove the panel from the

fig. 25

brewer, and set it aside. If the screw is tight,

you may need to use a flathead screw driver.

 

 

Pull the tube downward until the end is free

 

(fig25). Over a large pitcher, remove the plug

 

and drain the water from the Internal Hot

 

Water Tank into the pitcher. CAUTION: If the

 

brewer was not allowed to cool sufficiently,

 

the water draining from the tube may be very

 

hot. Re-cap the tube. NOTE: To avoid losing

 

parts, when finished, re-insert the tube and

 

screw the panel back onto the brewer.

17

Image 17
Contents Using Your Brewer Do not assume the next user will do this Important Safeguards Safe Operation & UseTable of Contents Helpful Hints Set-upUnpacking Instructions Please see pages 16 and 17 for instructionsLCD Screen Power Cord Drip Tray Base Brew Button Features Professional Series Model B155 BrewerCup Assembly Drip Tray Housing Drip Tray Plate Set-Up & First Brew Setting Up Your BrewerNext brew cycle fig Ready to Brew Your First CupPlace a mug on the drip tray and select Adding Water Stopping the Brew ProcessPurging the Brewer Brewing Hot WaterMenu Mode Menu Controls & IndicatorsAuto OFF Menu Key NavigationProgramming Brew Temperature 188-198º F Setting the ClockThat the brew size is disabled Programming On/Off FeaturesProgramming Your Brew Size From the Menu Mode, press Setting Contact Screen Language SettingsCleaning External Parts Cleaning & MaintenanceBack onto the K-Cup Holder Cleaning the Water Reservoir & Water Reservoir LidDe-Scaling Your Brewer De-Scaling Instructions ServiceStorage Drain the water from the Internal HotSituation Solution TroubleshootingKeurig, Incorporated WarrantyLimited One Year Warranty Fonctionnement et utilisation sans danger Règles DE Sécurité ImportantesProgrammation des fonctions de mise en marche et Table DES MatièresDéballage de la cafetière RéglagesConseils utiles ’assemblage du support à K-Cup ’égouttage Cuvette Caractéristiques Cafetière B155 Série professionnelleCouvercle du réservoir d’eau Réservoir d’eau Préparation de votre cafetière Préparation et première infusionPlacez une tasse de 296 ml 10 oz sur le Infusion de nettoyage. Remarque Ce cycle seInfusion de votre première tasse Ajout d’eau Annulation d’une infusionVidange de la cafetière Eau chaudeMode Menu Menu de commandes et voyantsLangue Navigation dans les menusRéglage de l’horloge « Formats » Programmation des formats d’infusionRéglage de la langue Réglage des coordonnéesAutomatiquement deux heures après la « Désactivé » apparaît à l’écran. Appuyez sur « OK »Nettoyage de l’assemblage du support à K-Cup Nettoyage et entretienNettoyage des pièces externes Détartrage Nettoyage du réservoir d’eau et de son couvercleEntreposage Procédure de détartrageRéparation Si l’écran ACL indique Problème SolutionDépannage Garantie limitée d’un an GarantiePage