Jura Capresso 13623 manual Permanently setting, Button.’ appears, Press button.’ appears

	2 Preparation
Permanently setting	It is easy to make permanent settings for the amounts (amount of
amounts for the cup size	water, amount of milk etc.) for all products according to the cup size.
	Adjust the amount once as shown in the following example. Every
	time you prepare a drink in the future, this amount of water will be
	dispensed.
	The permanent settings for adapting the amounts to the cup size
	for all products follow this model.
	Example: Proceed as follows to permanently set the amount of
	water for one coffee.
	Precondition: ‘Please select product:’ is displayed.
	T Place a cup under the dual spout.
	T Press and hold the ‘Coffee’ button.
	‘Coffee’ and the fill volume are displayed.
	T Hold the ‘Coffee’ button down until ‘Enough coffee? Press
	button.’ appears.
	T Release the ‘Coffee’ button.
	Preparation starts and the coffee flows into the cup.
	T Press any button as soon as there is sufficient coffee in the
	cup.
	Preparation stops. ‘Saved’ appears briefly on the display. The
	set amount of water for one coffee is permanently stored.
	‘Please select product:’ appears on the display.
	E You can alter this setting at any time by repeating the above
	procedure.
	E The amount can be permanently adjusted to the cup size for
	the products shown in the product selector too. To do this,
	press and hold the Rotary Switch k until ‘Enough coffee?
	Press button.’ appears.
	E You can also permanently set the amount for all specialty
	coffees, milk and hot water in programming mode (see Chap-
	ter 4 ‘Permanent settings in programming mode – Product
	settings’).

21