13a. INSTALLING & ACTIVATING THE CLEARYL WATER
CARTRIDGE
Installing:
Important: Never install the cartridge before or during "Preparing Machine For The First Time" (chapter 6).
•Remove cartridge from its bag and rinse cartridge under water.
•Add the extension rod to the cartridge (Fig. 11).
•Remove the water tank, make sure it is empty.
•Pull up the cartridge holder and insert the cartridge with its tapered end down into the water container (Fig. 12, Fig. 13). Make sure it fits securely inside the fins. Push down gently (Fig. 13).
•Close the cartridge holder. Make sure the holder snaps into place.
•Fill the water tank with fresh cold water and replace.
Activating:
You must activate the cartridge for the machine to monitor it properly. Otherwise the S9 OT assumes decalcifying mode.
COFFEE READY.
1.Push the Rotary Dial until display shows MAINTENANCE. 2.Turn the Rotary Dial until the display shows FILTER NO and
push the Rotary Dial to enter the program.
3.Turn the Rotary Dial until FILTER YES is displayed and push the Rotary Dial. CONFIRMED ✓is displayed briefly and then
INSERT FILTER/PRESS STEAM. The Rinse button illuminates.
4.Place a 20 oz. container under the frothXpress (Fig. 4) and turn the frothXpress dial to the 3 o'clock position.
5.Push the Rinse Button. FILTER RINSING. For the next 60 seconds the machine will push water through the cartridge
and out through the frothXpress system. Initially, the water may have a slight discoloration. The program will stop automatically. The display shows COFFEE READY.
6.Turn the frothXpress dial back to your preferred setting. Please note: As long as the filter is activated, the water hardness setting is automatically turned off.
13b. AUTOMATIC CLEARYL REPLACEMENT
The filter is monitored automatically. After approx. 75 liters of water (~2,500 oz.) the display shows COFFEE READY / CHANGE FILTER. The Rinse Button will light up. Important: Once the filter has lost its calcium suppressing abilities, calcium will build up inside the machine. Since the Water Hardness Selector is off, the machine will not remind you when to decalcify. If the filter is not replaced, the calcium build- up will clog and damage your machine.
•Push the Rinse Button. DURATION 2 MIN. / START YES. Please note: To change and activate the filter at a later time, turn the Rotary Dial until the display shows START NO. Push the Rotary Dial to exit the program. In this case the S9 OT will still remind you with the message CHANGE FILTER.
1. Push Rinse Button again. CHANGE FILTER /PRESS RINSE.
2. Remove the water tank and the old filter and set the extension rod aside. Important: Keep the extension rod.
3. Make sure the water tank is empty.
4. Remove the new cartridge from its bag and rinse under running water. Now install as explained in chapter 13a, steps 4 through 6.
23.