Jura Capresso 68193 Decalcifying Procedure Coffee Ready / Decalcify Machine, Manual Decalcifying

Page 34

17.1DECALCIFYING PROCEDURE COFFEE READY / DECALCIFY MACHINE

1. Push the Rinse button until display shows DURATION 45 MIN. / START YES.

Please note: To start at a later time, turn the Rotary Dial to START NO and push the Rotary Dial. The machine will still display COFFEE READY / DECALCIFY MACHINE.

2.Push the Rinse button again, display shows EMPTY TRAY.

3.Remove and empty the tray and the used coffee container

and replace, display shows SOLVENT IN TANK. Attention: If the tray and the used coffee container are empty, you must remove the tray for approx. 20 seconds and then replace it.

4.Remove the frothXpress system from the Auto Cappuccino system (Fig. 16).

5.Remove the water container and empty.

6.Completely dissolve 3 of the large square decalcifying tablets in a container with 20 oz. of water (0.6 liters) and pour the solution into the water tank.

7.Replace water tank. SOLVENT IN TANK/PRESS RINSE

8.Place containers under the Auto Cappuccino system and the hot water spout (Fig. 4).

9.Push the Rinse button. The display shows DECALCS and the light in the Rinse button flashes during the operation. The machine pumps the decalcifying solution in intervals through the Cappuccino system and the hot water spout. The display shows decalcifying status in the progress bar.

10.When display shows EMPTY TRAY, remove and empty the containers. Then carefully remove and empty the tray and the used coffee container and replace.

11.Display shows RINSE WATER TANK / FILL WATER TANK. Remove the water tank, rinse thoroughly, fill it halfway with fresh water and replace. The display shows PRESS RINSE.

12.Place containers under the auto cappuccino system and the hot water spout / coffee spouts (Fig. 4).

13.Push the Rinse button DECALCS.

14.The machine pumps fresh water through the system and stops automatically. The display shows HEATING UP. When the display shows MACHINE RINSING, hot water will flow through the coffee spouts. EMPTY TRAY.

15.Remove and empty the containers. Then carefully remove and empty the tray and the used coffee container and

replace. COFFEE READY.

The machine will automatically remind you when it’s time to decalcify again.

17.2 MANUAL DECALCIFYING

If you use very hard water it is possible that calcium builds up prematurely. If your coffee does not come out as hot as before it is a sign for calcium build-up. When this happens you can manually start a decalcifying cycle as follows:

COFFEE READY

Push the Rotary Dial until the display shows MAINTENANCE.

Push the Rotary Dial, display shows CLEAN CAPPUCCINO.

Turn the dial until the display shows DECALCIFY MACHINE and push the dial. The display shows DURATION 45 MIN. /

START YES.

Continue with the steps 2 through 15 from the chapter 17.1.

34.

Image 34
Contents Impressa S9 Important Safeguards Customer Service Jura-CapressoHeight-Adjustable Dual Coffee Spout Ground Coffee Button Service CoverLa Carte Button CUP Espresso ButtonExtension rod Frothing range Page Table of Contents Table of Contents Important / Battery BACK-UP Welcome to the Impressa S9 One TouchHigh Pressure Brewing PLEASE, DON’T... or you void your warranty protection3a. BEAN-TO-CUP / Crema Coffee 3b. Different Coffee DrinksPLEASE, do Factory Settings / OptionsXMILD, MILD, NORMAL, STRONG, Xstrong Preparing the Machine for the First Time Factory Settings for Beverage ButtonsOther Factory Settings 6a. Filling the Water TankCoffee Ready Adjusting the Grinder6c. Turning the Machine on for the First Time 6d. CUP IlluminationCoffee Preparation 9a. PRE-WARM Cups 8a. Turning the Machine OFF / Rinsing9b. Brewing Coffee and Espresso Example 9e. Using PRE-GROUND Coffee9c. Overriding Strength and CUP Size During Brewing 9d. the a LA Carte Button10a. Preparing the Thermal Milk Container Auto Cappuccino System10b. the Frothxpress System 10d. Preparing ONE-TOUCH Latte Macchiato 10c. Preparing ONE-TOUCH CAPPUCCINO, Café Mocha and Latte10e. Preparing HOT Milk / HOT Chocolate 10h. Using HOT Water 10f. Overriding the Cappuccino Settings10g. Cappuccino Rinsing Water Care Enough MILK?Enough COFFEE? 12a. Water Hardness Monitor12b. Changing the Water Hardness Monitor Clearyl Water Filter Cartridge13b. Automatic Clearyl Replacement 13a. Installing & Activating the Clearyl WaterInstalling CartridgeSetting AM/PM / OZ MaintenanceEconomy Mode Start YESTEMPERAT. Normal Coffee 3.5 OZEconomy Mode 1 Save Level Restoring Factory Settings for Beverage ButtonsEconomy Mode Save no Economy ModesActual Time and Weekday Economy Mode 2 Save LevelAUTO-ON and AUTO-OFF Times AUTO-OFF Rinse SettingsRinse cycle Init Rinse Fill System / Press Rinse Press RinseFill Water Tank Tray Missing Coffee Ready / Clean MachineCoffee Ready / Clean NOW Fill BeansEmptying the System Before Transport General Cleaning InstructionsCleaning the Frothxpress System EmptyingAutomatic Cleaning Cycles Cleaning with Special Tablet Manual Tablet Cleaning DecalcifyingDecalcifying Procedure Coffee Ready / Decalcify Machine Manual DecalcifyingError 2, Error Error Messages / TroubleshootingError 1, Error 3, Error Error 6, Error 7, ErrorSupplies Grinder Makes AN Extremely Loud Noise no Beans are GroundClearyl Water Filter Cartridge one included This Warranty does not Cover Auto-Cappuccino Cleaner one bottle included. Model #63801Limited TWO-YEAR Warranty You can order these suppliesPage Jura-Capresso Inc