Cisco Systems OL-20932-02 manual Installing the Cisco Physical Access Gateway, Before You Begin

Chapter 2 Installing and Configuring the Cisco Physical Access Gateway

Installing the Cisco Physical Access Gateway

Installing the Cisco Physical Access Gateway

•Before You Begin, page 2-7

•Procedure, page 2-7

Before You Begin

Before you install a Cisco Physical Access Gateway, verify the following:

•Verify that the module has access to a power source. See the “Power Options and Requirements” section on page 1-12for more information.

•Verify that you have the necessary mounting brackets or other hardware. See the “Mounting a Gateway or Optional Module” section on page 1-14.

Procedure

To install the Cisco Physical Access Gateway, perform the following procedure:

Step 1 Mount the Gateway to a wall. See the “Mounting a Gateway or Optional Module” section on page 1-14for more information.

Step 2 Connect the Gateway to a power source.

•If using a DC power source, insert a two-pin connector plug into the DC power port (Figure 2-4), and connect the Voltage In (VIN) and ground (GND) wires.

•If using PoE, connect an Ethernet cable from the IP network to the ETH0 port (Figure 2-4).

See the “Power Options and Requirements” section on page 1-12for more information.

Cisco Physical Access Gateway User Guide

OL-20932-02 2-7