Chapter 2 Installing and Configuring the Cisco Physical Access Gateway

Installing the Cisco Physical Access Gateway

Step 7 Connect the Gateway to the IP network by connecting an Ethernet cable to the ETH0 port, as shown in Figure 2-11.

Figure 2-11 ETH 0 Ethernet Connection for the Cisco Physical Access Gateway

271591

1

1

ETH0—Ethernet port for connecting the Gateway to the IP network.

Note The ETH0 connection can also be used for Power over Ethernet.

Note The ETH1 port is used to connect a PC to the Gateway for configuration and monitoring. See the “Configuring and Managing the Gateway Using a Direct Connection” section on page 2-15for more information.

Step 8 Continue to the “Configuring the Gateway Using the Cisco Physical Access Manager” section on page 2-23.

 

Cisco Physical Access Gateway User Guide

2-14

OL-20932-02

Page 38
Image 38
Cisco Systems OL-20932-02 manual 271591