Cisco Systems OL-20932-02 manual Output RED brown GRN orange

Chapter 3 Connecting a Cisco Reader Module

Installing the Cisco Reader Module

Chassis		One Reader	First Reader in a	Second Reader in a
Label	Description	10 Wire Connection	5 Wire Connection	5 Wire Connection
RED	Output	RED (brown)	3	GRN (orange)
			----------
BPR	Output	BPR (yellow)	----------	----------
	(Beeper)
HCRD	Hold	HCRD (blue)	----------	D1/CLCK (white)
	Control
CP	Card	CP (purple)	----------	D0 (green)
	Present

1.Wire colors are shown in parentheses.

2.Outputs show the LED color and reader wire color (in parentheses). For example, “GRN (orange)” supports a green LED. Attach the orange wire from the reader device.

3.---------- means the wire slot is not used.

Step 5 Connect input devices to the module:

a.Insert two-pin connector plugs into the input ports (Figure 3-10).

b.(Optional, for supervised input connections only). Install two End-Of-Line (EOL) 1K termination resistors in each supervised input interface (one terminator in each connector). Figure 3-9shows the terminator installation for a Normally Closed (NC) and Normally Open (NO) input connection.

Figure 3-9 Input Connections: Cisco Physical Access Gateway and Reader Module

1K,, 1%

NC

1K,, 1%

1K,, 1% 1K,, 1%

NO 187838

c.Connect the wires from the input devices (Figure 3-10).

Note Each of the input connections can be configured as supervised or unsupervised. The tamper and power fail inputs can be configured as additional unsupervised ports. A supervised input supports four states: normal, alarm, open and short. An unsupervised input indicates only normal or alarm.

	Cisco Physical Access Gateway User Guide
3-10	OL-20932-02