Cisco Systems OL-20932-02 manual 271593

Chapter 2 Installing and Configuring the Cisco Physical Access Gateway

Installing the Cisco Physical Access Gateway

Figure 2-8 Output Connections: Cisco Physical Access Gateway and Reader Module

271593

1

2

1	2	3	1	2	3	1	2	3
Normally Open (N.O.) connection						3	Normally Closed (N.O.) connection
C

Step 6 Connect optional expansion modules to the Gateway, if necessary:

a.Insert a three-pin connector plug into the CAN1 port, as shown in Figure 2-9.

b.Connect the CAN wires to the CAN bus, as shown in Figure 2-10.

c.On the last device in the CAN bus, set the CAN terminator switch to ON. The CAN terminator switch in included on the Reader, Input and Output modules only (the Gateway is always the first device in the CAN bus). Set the terminator switch to OFF for all other modules in the CAN bus.

Note Modules are connected using the CAN1 interface. The CAN2 interface is not supported in this release.

	Cisco Physical Access Gateway User Guide
2-12	OL-20932-02