Mitsubishi Electronics CP9500DW operation manual Error Messages & Countermeasures, Contents

ERROR MESSAGES & COUNTERMEASURES

INDICATIONS ON THE FRONT PANEL AND COUNTERMEASURES

2If, for some reason, printing is not possible or an error occurs during printing, the indicators on the front panel will illuminate or blink. In this case, follow the procedure described below.

In case of an error during printing, unless you turn off the unit, the unit resumes printing automatically when the error is corrected.

			: Steadyon	: off	: Blinking	: Depends on the previous condition
ALARM	PAPER/	DATA	READY COOLING		Causes and Countermeasures		Page
	INK RIBBON
				The door is open.			7

• Close the door.
A paper jam occurs.	19
• Refer to “Overcoming paper jams.”
The power is turned off during printing process.	---
• Turn on the power and carry out the paper feed & cut.
The temperature of the thermal head is too high.	7
• Wait until the indication goes off. * Note
The ink ribbon is not loaded.
The ink ribbon is used up.	14-15
The ink ribbon which is not available to this printer is
installed.
• Replace the ink ribbon with a new one.
The print paper is not installed.	12-13
The print paper is used up.
• Install new print paper.
The combination of the ink ribbon and the print paper is
incorrect.	14-15
• Use a correct combination of the ink ribbon and the
print paper.
Other errors	20

When ALARM or PAPER/INK RIBBON indicator illuminates or blinks, open the door and carry out the above countermeasures.

If the indicator is not turned off by closing the door, carry out the paper feed & cut.

*Note	If an error occurs while the continuous printing through the PC is ongoing, it is resumed after the COOLING indicator
	goes off.

PRECAUTIONS
FEATURES
CONNECTIONS
PREPARATION
SHOOTING	TROUBLE-
OTHERS

CONTENTS

18