Installation
4INSTALLATION
For your own safety and the safety of others, you must strictly comply with the “Safety Rules” described in section 3.
4.1Packaging
The original packaging was designed and made to protect the machine during shipping. We recommend keeping it for future transport purposes.
4.2Installation precautions
Before installing the machine, make sure to follow these safety precautions:
•put the machine in a safe place;
•make sure that children are not allowed to play with the machine;
•avoid placing the machine on very hot surfaces or near open flames.
Now the coffee machine is ready to be connected to the mains power supply.
4.3Mains connection
Electricity can be dangerous! There- fore, always strictly abide by the
safety rules.
Never use defective cords! Defective cords and plugs must be
immediately replaced by an Authorised Service Centre.
The coffee machine must be plugged into a suitable electric socket.
The voltage of the appliance is factory set. Check that the mains voltage matches the rating specified on the identification plate on the bottom of the appliance.
•Before plugging in the machine, make sure the ON/OFF switch is not pressed (2).
•(Fig.4A) - Put the socket into the outlet on the rear of the machine.
•Connect the other socket to a wall outlet having the proper voltage.
ENGLISH
4.4Filling the water tank
•(Fig.1) - Remove the water tank (1) taking care not to damage the water suction tube.
•(Fig.2) - Rinse out the tank and fill it with fresh drinking water, taking care not to overfill.
•(Fig.3) - Fit the tank again in its position, and place the tube previously removed.
Always fill the tank with fresh, still drinking water.
Hot water and/or other liquids may dama- ge the tank. Always make sure that there is sufficient water in the tank before starting the machine.
4.5Loading the circuit
Before starting the machine, if it has been inoperative for a long time and all the water has been used up, you must reload the circuit.
•(Fig.4B) - Press the ON/OFF switch (2). The light (3) will go on.
•(Fig.5) - Place a container beneath the steam tube. Turn the “hot water/steam” knob (7) counterclockwise to open.
•(Fig.6) - Press the coffee switch (4).
•Wait until a steady stream of water flows from the steam tube (“pannarello”).
•Press the coffee switch (4) again. Turn the “hot water/steam” knob (7) clockwise to shut off flow (Fig.7). Remove the container.
The machine is now ready to dispense coffee and steam; for a description of machine functions, see the specific sections.
5MAKING COFFEE
Warning!
While the brew unit is operating it is forbidden to remove the “Crema” filter holder by manually turning it clockwise. Danger of burns!
•During this operation the temperature ready light (5) may go on and off; this is normal and not to be considered a fault.
• 23 •