Saeco Coffee Makers SG200E Description of programming and maintenance phase keys

English

8.1Description of programming and maintenance phase keys

To surf inside the menu of the vending machine use the keys described below.

Key e: ENTER / beverage 05 (fig. 39)

By pressing this key it is possible to access the following level of programming or maintenance. Furthermore it is possible to modify or confirm the values set in the entries of the programming or maintenance menus.

Key c: CANCEL /beverage 01 (fig. 39)

By pressing this key it is possible to go back to the previous level of the programming or maintenance menu. It is also possible to avoid storing the values of the previously required modification.

Key ∫: DOWN / - sugar (fig. 39)

By pressing this key it is possible to access the preceding entry inside the same menu level. If used after requesting to modify a datum, it decreases its value of this same datum.

Key 〉: UP / - sugar (fig. 39)

By pressing this key it is possible to access the following entry inside the same menu level. If used after requesting to modify a datum, it increases the value of this same datum.

8.2 Programming menu

8.2.1Entering the programming menu

Open the door, insert the key into the safety switch (fig.18) and press key P1, located on the CPU card (fig.40, ref. 1) so as to enter the programming menu.

1

2

3

fig.40

If no password has been assigned you enter the programming menu directly.

Important

The structure of the programming menu is shown in 8.2.2.

8.2.3describes all the entries in the programming menu.

If a password to enable the programming menu was assigned to the vending machine, ‘PASSWORD 0000’ will appear on display with a flashing cursor on the first digit.

Now enter the password using UP and DOWN keys. Confirm the digit entered pressing the ENTER key.

To exit the programming menu and return to the normal operation of the vending machine:

-press key P1 again;

-remove the key from the safety switch to turn off the vending machine;

-close the door and wait for the self- configuration process to end.

27