RINSING
FILL HALF CARAFE WITH WATER. INSERT IN BREWING POSITION
RINSING
PLACE A CONTAINER
UNDER THE
DISPENSING SPOUT
RINSING
PAUSE
ENGLISH 83
Empty the milk carafe and fill half of it with fresh water. Insert it back into the machine with the dispensing spout open. Press the “
” but- ton.
Empty the container and place it back under both the milk carafe dis- penser and the dispensing spout. Press the “
” button.
The rinse cycle is activated.
Note:
To empty the container during the process and to pause the rinse cycle, press the “
” button. To resume the cycle, press the “
” button.
Note:
The rinse cycle is performed in order to have the circuit cleaned with a preset amount of water to ensure proper machine performance. If the water tank is not filled up to MAX level, the machine could require two or more cycles.
When the amount of water needed for the rinse cycle has been completely dispensed, the machine automatically ends the descaling process.
Note:
Wait until it has finished rinsing.
At the end of the descaling process, the machine performs an auto- matic rinse cycle. Wait until it finishes before removing and emptying the container.
Disassemble and wash the milk carafe as described in the “Weekly Cleaning of the Milk Carafe” chapter.
Empty the drip tray (internal) and place it back.
Remove the small white filter and place back the “INTENZA+” water filter into the water tank if it was installed.
Note:
At the end of the descaling cycle, wash the brew group as described in the “Weekly Cleaning of the Brew Group” chapter.