Rotel RSP-1098 owner manual Specifications, Audio, Video, General

Video and Audio do not match.

•Check that the proper video source is se- lected for each input.

•Check that the group delay (lip-synch) setting is not misadjusted.

Clicking or popping sounds when switching inputs.

•The unit uses relay switching to preserve maximum sound quality. The mechanical clicking of the relays is normal.

•During switching, it may take a split sec- ond for digital signals to be recognized and properly decoded. Rapid repeated switching between inputs or settings can result in clicks or pops from the speakers as the unit attempts to lock on to the rap- idly changing signals. This causes no harm.

Controls do not operate.

•Make sure that fresh batteries are installed in the remote.

•Make sure that the IR sensor on the front panel is not blocked. Aim the remote at the sensor.

•Make sure the sensor is not receiving strong IR light (sunlight, halogen lighting, etc.)

•Unplug the unit from the AC outlet, wait 30 seconds, and plug it back in to reset.

39 English

Specifications

Audio

Total Harmonic Distortion

<0.05%

Intermodulation Distortion (60 Hz:7 kHz) <0.05%

Frequency Response

10 Hz – 120 kHz, ±3 dB (analog bypass)

10 Hz – 95 kHz, ±3 dB (digital input)

Signal to Noise Ratio (IHF A-weighted) 95 dB (analog bypass)

92 dB (Dolby Digital, dts) 0dBFs

Input Sensitivity/Impedance

Line Level: 200 mV/100K ohms

Preamp Output Level/Output Impedance 1.0 V / 250 ohms

Contour (LF/HF)

±6 dB at 50 Hz/15 kHz

Decodable Digital Input Signals

Dolby Digital, Dolby Digital EX, DTS, DTS-ES,

DTS 96/24, LPCM (up to 192K), HDCD, MP3,

MPEG Multichannel

Video

Frequency Response

3 Hz – 10 MHz, ± 3 dB (Composite, S-Video)

3 Hz – 100 MHz, ± 3 dB (Component Video)

note: TFT screen displays Composite Video signals only.

Signal to Noise Ratio 45 dB

Input Impedance 75 ohms

Output Impedance 75 ohms

Output Level 1.0 volt

General

Power Consumption: 70 watts (normal)

60 watts (TFT screen off)

7.5 watts (standby)

Power Requirements (AC) 115 volts, 60Hz (USA version) 230 volts, 50Hz (CE version)

Weight

15.7 Kg/34.6 lb.

Dimensions (W x H x D) 432 x 164 x 435 mm 17.01" x 6.46" x 17.13"

Front Panel Height

(feet removed for rack mount)

150 mm / 5.91"

When sizing openings in custom cabinets, measure the unit to be installed and/or allow at least 1 mm clearance on all sides for unit to unit tolerances.

All specifications are accurate at the time of printing. Rotel reserves the right to make improve- ments without notice.

Rotel and the Rotel HiFi logo are registered trademarks of The Rotel Co, Ltd., Tokyo, Japan.