Turbo Chef Technologies NGC-1007 service manual PPHD, Cres, Assembly Notes

40 THE OVEN DOOR

50	49	APPLY HI-TEMP
		GREASE TO AREA

48	47
51
52

TOGGLE SHOULD BE LESS THAN

OR EQUAL TO 85º DOWN

SWITCH GAP = 0.020”

F I G U R E 29: Correct Primary and Secondary Interlock

Adjustment and Parts - Old Switch Setup

DOOR SWITCH ASSEMBLY AND PARTS

Figure 30, next page

53. NGC-1072 Bracket Latch

54.102012 Switch, Micro, 0.1A/125VAC

55.NGC-1087 Spring Door Latch

56. NGC-1073 Toggle, Latch

57.101119 Pin, Clevis, ø3/16 x 1” Lg

58.100059 Bearings, Bronze,

3/16ID x 5/16OD x 1/4” Lg

59.101557 Screw, #4-40 x 1.25” Lg,

PPHD, CRES

60.102921 Screw, #8-32 x 3/8”, Internal Tooth Sems, PPHD, SS

61.NGC-1126 Plate, Door Switch

62.NGC-3006 Grease, USDA H-1, Food Grade

63. 101296 Ring, E-clip

Assembly Notes

1.Ring, e-clip (Item 63) is supplied with Item 56.

2.Spring and bracket must be lubricated with high- temperature pure FM grease (Item 62).

3.Assembly must be hand-tightened prior to any final adjustment.

ADJUSTING THE MONITOR SWITCH - OLD SETUP

The old switch assembly is identifiable by the moni- tor switch being located on the right hinge assembly. Also, the serial number of the oven will follow this formatting (X = variable digit/letter):

NGC-XXXXX (North America)

NGCXX-XXXXX (International)

To adjust the switch, follow the steps below.

1. Ensure the oven door is adjusted. Refer to ADJUST-

ING THE COOK DOOR on page 38.

2. Turn on oven and bring it to the set temperature.

W A R N I N G : Oven surfaces are HOT! Use extreme caution when making adjustments.

3.Open and close the oven door several times to ensure the door closes smoothly and the door actuator (Item 47) clears the slot in the flange. Reference Figure 29.

4.Disconnect oven from power source.

5.To adjust the monitor safety switch (Figure 31), loosen the #8-32 screw and the two (2) #4-40 screws (Items 68 and 69) securing the switch.

6.Rotate the monitor safety switch (Item 65) until the gap between the switch paddle and the switch body is 0.02” (0.5 mm).

7.Open and close the oven door several times to make certain the adjustment is correct.

8.Tighten all screws.

9.Reconnect oven to power source.

10.Allow oven to sit at the set temperature for 10 minutes and confirm all adjustments.

MONITOR SAFETY SWITCH PARTS

Figure 31, next page

64. 102804 Hinge, Right

65.102012 Switch, Limit, Micro

66.NGC-1126 Plate, Door Switch

67.101912 Standoff, #8-32F/Fx1 in S

68.102921 Screw, #8-32 x 3/8”

69.102902 Screw, 4-40 x 5/8”