OPERATION
Oven Control, Clock and Timer
Your newcontrol has a series of tones that will sound at different times. These
tones may sound while you set the
control for an oven function, or at the
end of the oven function. It wilt also alert
you that there may be a problem with
the functions. Below are the types of
tones and a brief description of each.
TONES WHILE SETTING THE
CONTROL "When you press a touch pad you will hear a beep. This beep will
let you knowyou have placed enough
pressure onthe pad,to activate it. (The arrow pads do not beep.)
END OF TIMEDCYCLETONE -At
the end of an automatic timed cooking
function, you wilt hear 3 short beeps
followed by 1 beep every 6 seconds.
This 6 second beep wil! continue to
sound until the CLEAR/OFF pad is
pressed or you may selectthe specia feature to cancel this 6 second beep
from sounding at the end of future cycles.
TO CANCEL THE 6 SECOND
BEEP
1.Press and hold the BAKE and
BROIL pads, at the same time
for 3seconds, until the display
shows "SF." -
2.Press the KITCHEN TIMER
ON/OFF pad. The display will show "CON BEEP" (continuous beep).
3.Press the KITCHEN TIMER
ON/OFF pad again. The display will
show "BEEP" (beep canceled).
4.Press the START pad to cancel the
6 second beep and leave the:
special,feature: mode.
If you would like to return the 6 second beep, repeat steps above until the display shows your choice and press
the START pad.
will
oversight is madewhile setting an oven function.
Examples would be:
a. Setting a clean cycle and the oven
door is not properly closed.
b. Setting function and not pressing the
START pad.
c. Pressing an additional function pad without first setting a
temperature or time.
d. "ERR" will flash if you set an invalid
temperature. Press the CLEAR/OFF pad to clear the control and reset your oven function.
Any of these can be quickly identified
by watching the display.
PREHEAT TONE "When you
set an oven temperature, the oven
automatically starts to heat. When the
temperature inside the oven reaches
the temperature you have set, a tone will sound to
tfyou set an oven function and the control beeps while the display is flashing "F" and a number or letter
such as "F4" or "FI,," there may be a problem with the control or oven.
Simply press the CLEARIOFF pad and wait about an hour. Try setting the function again. If the code repeats, write down the flashing code and call for service. Tell the technician what code was flashing.
12