Kenmore 911.46565, 911.46566, 911.46569 owner manual Clean Drip Bowl, Aution=, To Replace the Unit

CARE AND CLEANING

Removable Parts

=11. Grasp the edge of the cooktop and lift up.

2. Holding the cooktop with one

hand, lift the support rod up and

rest the edge of the cooktop on it.

3. When cleaning is finished, lower

the support rod and the cooktop.

r_	CAUTION:		When		be
	working		in this	area,
careful		not to	bump	into	the
support		rod(s).	The	porcelain
enamel		surface	of	the
cooktop		can	chip	if dropped.
				• I	iii

Element _

Drip Bowls "l-

Receptacle

TO REMOVE

tl, Be sure the controls are in the off position and the elements are cool

before attempting to remove them.

2.Grasp the element and lift slightly, just enough to clear the drip bowl and pull it straight out.

CAUTION=	Do not		lift
I I IIII[	I I I	more	ItL I J . l_i _
the element			than

1% Lifting the element more

than 1" can damage the

receptacle,causing the

element not to lie flat when

it is plugged back in.

3.Lift out the drip bowl .... _ "

TO	CLEAN			THE		DRIP		BOWL
For	brown			food		stains		-	Use
dishwashing				detergent,				warm	water,
plastic		scouring			pads,		mild abrasive
cleaners,			soap-filled				scouring		.pads
or ammonia.				Clean		drip		bowls	after
each	use.		Rinse		and		dry	well,	Foods
that	are	not removed					can	cause ....
permanent			stains		that		cannot		be
removed.			For	heavily			soiled		bowls,
place	an ammonia-soaked							paper
towel	over		the	bowl		to loosen			the	soil,
then	gently		scrub		the bowl with a
plastic		scouring			pad.
For	blue.gold				heat		stains		-	Use

a metal polish; These stains are

caused by overheating, and are

usually permanent. To help minimize

this effect, avoid excessive use of

high heat settings and use flat bottom pans that do not extend more than 1"

from the edge of the cooking element.

IIIIII IIIIII11 [I I

_	AUTION=		the	Do not
	operate			cooktop
elements		without		the	drip
bowl	in	place.	Scorching			of
the	cooktop,		burning		of
wiring		insulation		and	loss	of
energy		wii! occur.		ii	i ii	ii i

TO REPLACE THE UNIT

t, Place the drip bowl into the opening and make sure the

receptacle is visible.

2, Slide the element firmly back into

the receptacle and lower it onto the drip bowl.

2.5