Kenmore 790. 7830, 790. 7840, 790. 7841 manual Setting Surface Controls, Setting surface burners

Page 10

Setting Surface Controls

Setting surface burners

Your gas appliance may be equipped with different sized surface burners. The ability to heat food quicker and in larger volumes increases as the burner size increases. It is important to select cookware that is suitable for the amount and type of food being prepared.

The smaller cooktop SIMMER burner (right rear cooktop position) is best suited for simmering delicate sauces, etc.

The standard size cooktop burners may be used for most surface cooking needs. Some models are equipped with an oblong shaped CENTER burner. This burner is rated 10,000 BTU and will heat like any other standard sized burner.

The larger cooktop POWER burner (on some models) or TURBO BOIL burner (on some models) are recommended for bringing large quantities of liquid to temperature and when preparing larger quantities of food.

To set surface burners:

1.Place cooking utensil on center of surface burner grate. Be sure the cooking utensil sets stable on the burner grate.

2.Push the desired surface control knob in and turn counterclockwise out of the OFF position (Fig. 1).

3.Release the surface control knob and rotate to the LITE position. Visually check that the burner has lit.

4.Once the burner has a flame, push the control knob in and turn counterclockwise to the desired flame size.

Use the control knob markings and adjust the flame as needed.

\

Fig. 1

Do not place flammable items such as plastic salt and pepper shakers, spoon holders or plastic wrappings on the cooktop when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire if placed too close to the range cooktop.

Do not place aluminum foil, or ANY

material that can melt on the range cooktop. If these items melt they may permanently damage the cooktop surface.

Important notes:

•DO NOT cook with the surface control knob left in the LITE position. The electronic ignitor will continue to spark if the control knob setting remains in the LITE position.

When setting any surface control knob to the LITE position, all electronic surface ignitors will spark at the same time. However, only the surface burner you are setting will ignite.

•NEVER place or straddle a cooking utensil over two different surface cooking areas at the same time. This can cause uneven heating results.

In the event of an electrical power outage, the surface burners can be lit manually. Use caution when lighting surface burners manually. To light a surface burner, hold a lit match to the burner head, then slowly turn the surface control knob to LITE. After burner lights push in and turn knob to desired setting.

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Ienmore Elite Kenmore Elite Limited Warranty Table of ContentsSave these instructions for future reference Serious injuryImportant Safety Instructions IgniteImportant safety notice COOlTOPGrounding Instructions Product RecordSerial Plate Location Conversion to L.P. GasRange Features Your gas range features includeRemoving, replacing and arranging oven racks Before Setting Oven ControlsTypes of oven racks Air circulation in the ovenSetting proper burner flame size Before Setting Surface ControlsUsing proper cookware Cookware material typesSetting Surface Controls Setting surface burnersOperating the Double Ring Burner Setting Double Ring Burner some modelsHome canning IDo not place flammable items such asOven Control Functions Minimum & maximum control settingsFeature Oven control keypadsSetting Timer Setting Oven ControlsSetting Clock Setting 12 or 24 hour display modeSetting silent or audible control mode Changing oven temperature display modeOven Lockout Press 4 5 0 using numeric keypads Setting PreheatSetting Bake Example To set Bake with default oven temperature 350FSetting Delay Start Setting Cook TimeWhen the programmed cook time runs out Conv Bake Example m To set Conv Bake with a default oven setSuggestions for Convection baking Conv Convert Cony RoastSuggestions for Conv Roast 1st side Suggested broil settings table gas ovenBroil ThickCakes Breads Meat probe some modelsMeat probe contd To set meal probeSetting Slow Cook Some tips for best results when using Slow CookRecipe Recall Setting Oven Controls Warm & Hold TMExample m To set Warm & Hold Operating oven lights Example To adjust Accent light brightnessAccent light Restoring factory default settings Adjusting oven temperatureExample m To restore to factory default settings Sabbath feature for use on the Jewish ModesExample m To turn off the Sabbath feature Warm & Ready TM drawer some models Warmer DrawerArranging warmer drawer rack positions Warmer drawer controls Warmer drawer settingsWarmer drawer recommended food settings Food To set warmer drawerTo set Proof Bread using warmer drawer Proof BreadSee Fig Removing and replacing the warmer drawerDrawer To replace the warmer drawerFlex Clean Setting Flex CleanWhen Flex Clean is finished Delayed Start Flex CleanIf it becomes necessary to stop Flex Clean when active Care & Cleaning Cleaning recommendationCleaning surface burner heads Cleaning the cooktop and surface burnersCleaning burner caps To clean the burner head ignition portsAluminum foil and utensils General cleaningReplacing oven lights Special door care instructions Removing and replacing the lift-off oven doorRoller Pin Setting SolutionAppliance connector Installed Is notSection See Cleaning Protection Agreements Acuerodes de proteccibnSears Parts & Repair Service Center Iiiiiiii

790. 7841, 790. 7830, 790. 7840 specifications

The Kenmore 790 series of appliances, particularly models 7840, 7830, and 7841, represents a blend of advanced technology and user-friendly design in kitchen ranges. Known for their reliability, these ranges come with several standout features and characteristics that cater to a modern cooking experience.

One of the defining features of the Kenmore 790 series is the powerful oven performance. Each model is equipped with a precise oven temperature control system that ensures your dishes are cooked evenly. The range often includes multiple cooking modes, such as bake, broil, and roast, allowing users to adapt their cooking methods to a variety of recipes. The convection baking feature in some models enhances heat distribution, reducing cooking times while ensuring that food develops a perfect golden-brown crust.

The cooktop of the Kenmore 790 series showcases versatility, often featuring a combination of sealed burners that provide quick and efficient heating. With different burner sizes, users have the flexibility to adjust for various cooking needs, from simmering delicate sauces to boiling large pots of water. Certain models include a high-output burner, which is ideal for stir-frying or searing meats, making it a favorite among culinary enthusiasts.

In terms of design, the Kenmore 790 ranges present a sleek and modern aesthetic. Stainless steel finishes not only add elegance to the kitchen but also ensure durability and ease of cleaning. The intuitive control panel often features digital displays and touch controls, allowing for easy navigation of settings and timers.

Safety is also a priority with the Kenmore 790 models, which include features like an automatic shut-off function that provides peace of mind during cooking. Many models come with a self-cleaning option, simplifying maintenance by using high temperatures to burn off food residues.

Another impressive characteristic of the 790 series is its energy efficiency. These ranges are designed to reduce energy consumption without compromising performance, making them a smart choice for environmentally conscious consumers.

Overall, the Kenmore 790 series, including models 7840, 7830, and 7841, offers reliable performance, versatility, and modern features that enhance any kitchen experience. They embody Kenmore’s commitment to quality and innovation, making them an excellent choice for home cooks seeking both functionality and elegance.
Top Page Image Contents