:LOCI< CONTROLS / LOCI<
[_ The LOCI< CONTROLS/LOCK button
HOLD3SECS deactivates the temperature controls
TYPE1 TYPE2and dispenser functions. Press and hold this button for 3 seconds or until the Loci< indicator light is
lit. To disable the Loci< function, press and hold the LOCI<
CONTROLS/LOCI< button for 3 seconds or until the Loci<
indicator light is off.
Door Alarm
When either refrigerator or freezer door is left open for more than 60 seconds, an alarm will sound 5 times at 30 seconds intervals to let you know the door is open. Please contact the local service center if warning tone continues to sound even after closing the door.
C.ANOEH_2T_R
FILTER RESET
HOLD 3 SECS
ADJUSTING CONTROL SETTINGS
Give the refrigerator time to cool down completely before making final adjustments. It is best to wait 24 hours before
doing this. The initial settings mentioned in CONTROL PANEL FEATURES section should be correct for normal household
refrigerator use.
The refrigerator control functions as the thermostat for the entire appliance (refrigerator and freezer sections). The colder the setting, the longer the compressor will run to keep the temperature colder. The freezer control adjusts the cold air flow from the freezer to the refrigerator. Setting the freezer control to a lower temperature keeps more cold air in the freezer compartment to make it colder.
If you need to adjust temperatures in the refrigerator or freezer, start by adjusting the refrigerator. Then wait 24 hours before checking the freezer temperature. If it is too warm or too cold, then adjust the freezer control.
Use the settings listed in the chart below as a guide. Always remember to wait at least 24 hours between adjustments.
°There is a replacement indicator light for the water filter cartridge on the dispenser.
°Water filter usually needs replacement once every six months.
°Filter light comes on and blinks to let you know when to replace filter.
°After replacing filter, press and hold Filter Reset button for 3 seconds to turn off filter status light.
( 1 Ice&Water 1 1 _CE & WATER
(Identify your icon type)
You can select between the water or ice options.
*Select Water, Crushed Ice or Cubed Ice by pressing the ICE & WATER button to the selection desired. The Water,
Crushed Ice or Cubed Ice icon will light up to indicate selection.
Cube
Selecting this icon indicates that cubed ice will be dispensed when the dispenser pad is activated.
TYPE 1 TYPE 2
Water
Selecting this icon indicates that water will be dispensed when the dispenser pad is activated.
TYPE 1 TYPE 2
Crushed
Selecting this icon indicates that crushed ice will be dispensed when the dispenser pad is activated.
TYPE 1 TYPE 2
To dispense water or ice, gently push your cup against the dispenser pad.
NOTE: Hold your cup in place for a couple of seconds after
dispensing ice or water so the last few drops go in your cup instead of on the floor.
CONDITION/REASON
[] REFRIGERATOR section too
warm.
°Door opened often.
°Large amount of food added.
°Room temperature very warm.
[] FREEZER section too warm/ice not made fast enough.
°Door opened often.
°Large amount of food added.
°Very cold room temperature (compressor does not cycle often enough).
°Heavy ice usage.
°Air vents blocked by items.
[] REFRIGERATOR section too cold.
°Controls not set correctly for your conditions.
[] FREEZER section too cold.
°Controls not set correctly for your conditions.
RECOMMENDED ADJUSTMENT:
Press the REFRIGERATOR control
to next coldest level, wait 24 hours.
Press the FREEZER control to next coldest level, wait 24 hours.
Move items out of airstream.
Set REFRIGERATOR control to next warmer level, wait 24 hours.
Press the FREEZER control to next warmer level, wait 24 hours.
17