Application Guidelines/Water Supply Parameters
Service Flow | 0.5 | gpm | (1.9 | lpm) | |
Water | Supply | Potable | Water | ||
Water | Pressure | psi (138 - | 827 kPa) | ||
Water Temperature 33°F - 100°F (0.6°C - 38°C)
it is essential that the manufacturer's recommended
installation, maintenance and water filter replacement requirements be carried out for the product to perform as advertised.
NOTE: While the testing was performed under standard laboratory conditions, actual performance may vary.
For estimated costs of replacement elements, please call
www.sears.com/partsdirect
3M is a trademark of 3M Company. NSF is a trademark of NSF International.
© 2009 3M Company. All rights reserved.
To reduce the risk associated with ingestion of contaminants: Do not use with water that is
microblologlcally unsafe or of unknown quality
without adequate disinfection before and after of the system. Systems certified for cyst reduction may be used on disinfected water that may contain filterable cysts. EPA Establishment Number
To reduce the risk associated with property damage due to water leakage:
Read and follow the Water Filter instructions before installation and use of this system.
Installation and use MUST comply with all state and local plumbing codes.
Do not install if water pressure exceeds 120 psi (827 kPa). Contact a plumbing professional if you are uncertain of how to check your water pressure.
Do nat install where water hammer conditions may occur. If water hammer conditions exist, you must install a water hammer arrester. Contact a plumbing professional if you are uncertain of how to check for this condition.
*Do nat install on hot water supply lines.
The maximum operating water temperature of this water filter system is 100°F (38°C).
*Protect water filter from freezing. Do not operate refrigerator in ambient conditions below 55°F (12.7°C). Drain water filter when storing unit in temperatures below 40°F (4.4°C).
The disposable water filter must be replaced every six months, at the rated capacity, or if a noticeable reduction in flow rate occurs.
31